Naim Audio NAP-6-50 6 channel amp, get Naim sound throughout your house

Rare Naim 6 channel amp. 30 WPC. Serial number makes it a 2001 model. Intended as a multi-zone amp allowing you to get that famous Naim sound throughout your house. I really have no idea what this is worth or the demand for it. Starting at $999 but open to reasonable offers. I got it from the guy who was the Naim distributor at the time it was made, It has a few marks on the case but overall looks very good.
Typical Naim I/O scheme with 4 pin DIN for each stereo input and banana speaker out. Not speaker cable dependent like most Naim amps.
I was using it to tria-mp my horn system and it really sounds good. Only surpassed by much more expensive Naim amplification. I then intended to use it as a 6 zone amp using the Zone 2 output on my AV Receiver mixed to mono but so far too lazy to run the wires. If it doesn't sell I'll end up doing that as it will sound much better than all but the most expensive wifi speakers. Can also use it as 3 zone stereo amp.
I have a 3 Chord Stereo XLR to 4 pin DIN cables if you have a balanced preamp. I also have a another set of Naim 4 pin DIN that I can configure with RCA to connect to your SE preamp. The cables are as shown except what were the RCA ends were it is currently unterminated as I had it being fed from a Pro audio interface that has a DB25 output. I am a professional electronics tech so can put whatever you want on those.
.. From the Naim brochure NAP 6-50 six-channel power amplifier
The multi-room NAP 6-50 provides six channels of Naim quality amplification
for users installing multi-room systems. To integrate into such systems it
provides a low power standby mode, control line input or signal sensing to
‘wake up’ out of standby mode, the ability to drive long and varied speaker
cables, and electronically controlled fan cooling. .
Each of the six power amplifier sections is a version of the new circuitry
developed for the NAP500. Each two-channel zone uses a separate power
supply with its own transformer winding.
The standby mode is designed to minimize power consumption while the fan
control circuitry adjusts the fan speed to suit the demands placed upon the unit.
Specifications
Power output continuous [8 Ohm] 30 Watts per channel
Control line 4.5 - 12V
Standby power consumption <1W
Mains supply 115V, 230V (50 or 60Hz)
Dimensions (H x W x D) 87 x 432 x 314mm
Finish Black