Tannoy KENSINGTON SE THE KENSINGTON SE-MAHOGANY FINISH

These Speakers are in great condition and only have has one cosmetic blemish in the back left edge which you can highlighted in one of the pictures.

THESE ARE LOCAL PICK UP ONLY.

We are selling this for a client of ours and we do not have the boxes for them so they can not be shipped.

The
Kensington

In
combining the best of traditional crafts with the latest production and design
skills Tannoy presents the Kensington loudspeaker. The Kensington embodies the
Tannoy philosophy. Cabinets in selected hardwoods are hand finished and polished
to a standard that is unsurpassed.

 

Technical
Specifications

CABINET
DIMENSIONS       

1100H
x 406W x 338D mm

 

ENCLOSURE
VOLUME

105
litre

 

ENCLOSURE
TYPE      

Coupled
reflex distributed port

 

REC.
AMPLIFIER POWER     

50
to 225 watt per channel

 

POWER
RATING         

135
watt RMS 400 watt peak

 

MAXIMUM
SPL           

114
dB at 1 metre for 135 watt RMS

119
dB at 1 metre for 400 watt peak

 

TOTAL
HARMONIC DISTORTION

Less
than 1.2% at 135 watt RMS (50Hz to 20kHz)

 

SENSITIVITY              

93
dB for 2.83 volt at 1 metre

 

NOMINAL
IMPEDANCE       

8
ohm

 

MINIMUM
IMPEDANCE       

5.5
ohm

 

DISPERSION               

90
degree conical

 

PHASE
RESPONSE      

System
behaves substantially as a frequency independent time delay

 

FREQUENCY
RESPONSE      

29
Hz - 22 kHz, -6dB

 

CROSSOVER
FREQUENCY   

1.1
kHz      

 

CROSSOVER
ADJUSTMENT 

+/-3
dB over 1.1 kHz to 22 kHz shelving

+2
dB to -6 dB per octave over 5 kHz to 22 kHz slope

 

CROSSOVER
TYPE      

2nd
order compensated LF,

2nd
order compensated HF.

Bi-Wired,
Hard-Wired passive, low loss. Time compensated

 

DRIVER
TYPE    

250
mm (10") Dual Concentric, treated paper cone

Alnico
magnet system, twin roll fabric surround.

 

CABINET
CONSTRUCTION  

High
density 18mm birch ply baffle and rear panel

Top
and sides 18mm particle board.

Internally
crossbraced and heavily damped

Also available in separated ads are a Jeff Roland Pre-Amp and Mono Block Amps that the client powered these with.