Oracle Audio Technologies PH200

Oracle PH200 phonograph pre-amplifier with an outboard power supply in gloss black finish.  The PH200 enables the adjustment of the Load and Gain for cartridge compatibility.  The PH200 external power supply is designed in a separate chassis to isolate the idiosyncrasies of the power supply to audibly affect the main pre-amp component performance.  The unit was a demonstration unit and lightly used.  There is on the one side near the top edge of the main component two small markings.  The marks are not visible looking at the front of the unit.  The top view shows slightly the marks if your looking for them.  The marks are primarily visible from the side.  Have to rate a 7 out of 10 because of the marks but overall some of you may rate a bit higher than my rating.

Shipping - Included with purchase of the cable within Canada and most contiguous
United States(lower 48 states) only. Shipping cost is added to buyers in
Alaska, Puerto Rico, Hawaii,  Guam and Virgin Islands.

About the Paris PH200 phono pre-amplifier
           

The distinctive design of the
Paris PH200 with its elegantly sculpted chassis carries the unique signature of
the Paris series. The secret behind the overall tonal balance and performance of
the Paris phono preamplifier lies in the careful selection and combination of
the different components. The internal circuitry of the Paris PH200 is a two
stage design. The first stage has for role to amplify the faint signal coming
from the phono cartridge in order to present the signal with an acceptable
level to the straightening RIAA curve circuit. The second stage has for role to
amplify the signal to the required output level of the PH200. Both amplifying
stages were designed such that they optimize the signal to noise ratio of the
PH200 which results in a very rapid and high dynamic contrast giving to the
Ph200 all its musicality!  
         

The Paris PH200 distinguishes
itself from the PH100 as it is equipped with an additional signal regulation step
located just before the RIAA circuit input and also by the usage of higher
quality operational amplifiers on the analog amplifying modules further
improving the sound. The last of these distinctions and not the least is the
usage of a highly regulated and filtered external power supply. Extreme care
and attention has been applied to eliminate the electrical line noise before it
can access the Paris phono stage circuitry. The PH200 has been designed to accommodate usage of both moving coil and moving magnet phono cartridges. The
PH200 offers variable moving coil cartridge load settings and variable gain
using jumper configurations on both the left and right channels. The different
values of load impedance and gain that are possible are listed on the technical
specifications page of the PH200. The Paris PH200 will bring you to a
re-discovery of your record collection and will provide countless hours of
enjoyable and satisfying musical experience!

 https://www.oracle-audio.com/paris-ph200