Anthem PRE-1L

Up for sale is an Anthem Pre-1L preamplifier in very good condition. No cosmetic or functional issues, though it has seen a few years of gentle use. I/O-wise, it has four line inputs, a tape loop, two main outputs, and a headphone jack. Functionally similar to the Anthem Pre-1, minus the external power supply and phono stage, although apparently the electronics are completely different.

This box includes 3 matched sets of 6922 tubes, one set each of:
* Electro-Harmonix 6922EH
* JJ E88CC
* National Electronics 6DJ8/ECC88
I could not tell you which ones sound better than the others, but I suspect they all have some useful life left.  These come uninstalled for safe shipping. Thankfully the box also includes the screwdriver for the 17 screws in the unit's case. (Sorry, I must have lost a screw.) 
 
Technical Specifications:
(AC line set at 117V 60Hz)
FREQUENCY RESPONSE: 2 Hz to 130 kHz -0.5 dB; > 250 kHz -3.0 dB at 1VRMS output
THD & N (Output at 1V RMS): < 0.1% from 20 Hz to 20 kHz
GAIN: Selectable, 24, 16 & 8dB settings @ 1kHz
INPUT IMPEDANCE: 40k ohms
OUTPUT IMPEDANCE: <135 ohms @ 1kHz, all gain settings.
RATED OUTPUT: 1 VRMS
MAXIMUM OUTPUT VOLTAGE: 30 VRMS at 1% THD
NOISE: < 115µV unweighted wideband noise Approx. 60µV IHF A-weighted noise-90 dB A-weighted below a 1 VRMS output
STEREO SEPARATION (Crosstalk): > -60dB @ 1kHz relative to 1 VRMS output
TUBE COMPLEMENT: 4 - 6922 (6DJ8 types)
FUSE REQUIREMENTS (1): .75 A slow-blo (100-120VAC countries), .375A slow-blo (220-240VAC countries)
POWER REQUIREMENTS: 40VA
DIMENSIONS: 19” Wide x 11” Deep x 5.25” High
NET WEIGHT: Approx. 20 lbs (9 kg) - unpacked