Krell FPB-200 NEW CAPS
Listed · 1238 Views
19 Watchers
Items from this seller
This listing has ended.
Listings Similar to Krell
Time Left: Listing Sold
This listing has ended.
Condition | |
Payment methods | |
Ships from | Glencoe, MN, 55336 |
Ships to | United States |
Package dimensions | unspecified |
Shipping carrier | UPS |
Shipping cost | $149.00 |
Original accessories | Box, Manual |
Average | Research Pricing |
THIS AMP HAS A USED PRICE OF $3000.00 ALL ELECTROLYTIC CAPS REPLACED BY PREVIOUS OWNER AND I CHECKED TO VERIFY. This is one of the best sounding amps that I have ever had. Full soundstage with great bass, full mids and sharp highs. THIS AMP SOUNDS GREAT This Krell amplifier power output specs have always been rated very conservatively, and with both channels driven, and always operating in full class-A, this guy is capable of 200W into8 ohms, 400W into 4 ohms, 800W into 2 ohms, and is stable driving even a 1 ohm load. This is possible because the power supply is built around a 2 KVa transformer! The FPB-200 is fully balanced, input to output, and also features fully regulated output devices,meaning each output transistor has its own high-speed active regulator to ensure that fluctuations in rail voltage cause no sonic degradation. These amps changed the way the industry thought about power amplifier performance, A true Class A amp, Frequency response: 20Hzto 20kHz Total harmonic distortion:0.15% Gain: 26.4 dB Input sensitivity: 1.92V Signal to noise ratio:113dB 200 watts/Channel at 8ohms 400 watts/Channel at 4 ohms 800 watts/Channel at 2 ohms Accepts balanced/unbalanced inputs. Comes with IEC 320 20 AMP POWER CORD manual and original box, AMPLIFIER GOES INTO STANDBY MODE IF PUSHED AT HIGH VOLUMES (OTHERWISE IT SOUNDS GREAT) MANUAL STATES IT IS INSUFFICIENT POWER FROM WALL OUTLET, I DO NOT HAVE A DEDICATED OUTLET FOR THE AMP. SEE PICTURE. MANUAL RECOMMENDS A DEDICATED 15 AMP OUTLET FOR FULL POWER AMP MAY NEED BIAS AND OFFSET ADJUSTMENTS BY A QUALIFIED TECH
Questions for the seller |
---|
When did the previous owner replace all the caps (as stated in the front page)? Is the receipt or paper work on the replacement available? Thank you.
Ed Tan NOT SURE A TRANSISTOR NEEDED REPLACING AND THATS WHEN IT WAS OBVIOUS THAT ALL THE ELECTROLYTIC'S WERE REPLACED BECAUSE OF THE NEW SOLDER JOINTS |
Ask the seller a public question
You must log in to ask a question.
Return Policy
Return Window
Item can be returned within 3 days of receipt.
General Terms
Items must be returned in their original condition, with all included packing materials and no signs of use. Buyer assumes responsibility for all shipping return costs unless the item was not received as described.
Refunds
Buyer will receive a full refund in the original payment method less any shipping charges.
Special Conditions
ITEMS MARKED AS IS ARE NON-RETURNABLE