PS Audio P10 Power regenerator

This P10 works excellent. It was used by a manufacturer at audio shows. In between it was stored so it has very low hours. It is less than 2 years old. Isolation transformers cannot come close to cleaning the noise spectrum (especially the low end just above 60 Hz), like the P10 does. In the pictures you can see the sine wave before and after cleaning. You can also see the approximate 2% incoming noise reduced to .1% ! You can easily hear this in the sonic result. Most incoming power around the country we have seen runs 3% to 5%. Even then the P10 cleans to .2% to .3%. I tend to run the plain sine wave and the high regulation mode. It seems to sound best in most venues. Certainly you should read the manual and try the various settings with your own gear. This unit is in excellent condition. There some hazing in the top cover which is a heavy plastic plate. I think this is from the styrofoam arch that is part of the packing. It is not scratched per se so it will likely come out with some common plastic polish and some elbow grease. The P10 will run amplifiers and front ends at the same time. I suspect it will run most amps except for big class A or very huge AB amps. Used on larger-medium size and smaller amps and front ends it is loafing. There is a readout to see the percentage of the P10s capacity being used. With 200 watt class A mono blocks it was at 40%. I used a P10 on each mono block with a great result. I have two of these but I am keeping one for use on front ends since the amps I use now have their own internal line conditioning and are completely insensitive to wall power. I rated the P10 excellent because I think it is virtually flawless except of the hazing in the top. It comes with the manual, remote and CF card. It is in the original packaging. I am open to offers, Thanks for looking.