Bottlehead SeductionPhono Preamplifier Bottlehead Seduction Phono PreamplifierSelling my Bottlehead Seduction Phono stage with GE military 6DJ8s tubes… Works and sounds wonderful and I am only selling it because I don’t used it anymore and I have even sold my MMF 7 turntable...425.00

Bottlehead Seduction Phono Preamplifier [Expired]


no longer for sale

Selling my Bottlehead Seduction Phono stage with GE military 6DJ8s tubes… Works and sounds wonderful and I am only selling it because I don’t used it anymore and I have even sold my MMF 7 turntable that I had hooked up it for 4 years… This was built from a kit and assembled a local tube amp builder and current member of the Dallas Audio Club…. The Kit now cost $369.00 plus $225.00 if you have it built… http://www.bottlehead.com/store.php?crn=225&rn=429&action=show_detail The phono preamp has a gain of approximately 36 dB at 1 kHz and is intended for use with phono cartridges of 2.5mV and higher output, with 5mV output being the design center. Higher than 5mV output is certainly fine, and one may also use lower output cartridges with a suitable step up device. Input impedance is 47.5K ohms, input capacitance is 50pF. Remember that your phono cable's capacitance will add to this figure and increase your cartridge's capacitive load somewhat. Frequncy response exhibits +/- 0.3dB RIAA curve accuracy. The Seduction is designed to operate into line stages with 50K or higher input impedance through interconnects of 1M or shorter length. The Foreplay III line stage is the best possible match, and the combination of the two will make for a most satisfying two-chassis full preamp setup
Seller Information

bearhifi 

Last 12 months
All-time15100.0%

Member since September 2004

Items from this seller