Granite Audio Model 433 Pure Copper Interconnect.

NEW 2012 Product for the Demanding Audiophile.from Granite Audio

Granite Audio
Model 433 Pure Copper Interconnect.
The finest quality solid copper.
99.999% pure slow-drawn continuous-cast continuous-crystal
oxygen-free copper.

BRAND NEW FROM GRANITE AUDIO -- now a new pure copper interconnet

SPECIAL INTRODUCTION SAME -- SPECIAL PRICE TILL END OF MARCH --

@@@ Please contact us direct for any questions or to buy the Cables
contact us at [email protected] or call us at 215-953-9099 @@@

This cable is engineered for the maximum in pure music clarity and value.
The subtle details of vocals and instrumentals flow cleanly through the twin
22-gauge pure copper wires. With 100% pure copper wire shielding. Hear all
your music through these virtually perfect wires.

The #433 RCA is a 3-conductor single-ended cable with a low noise floor that
rivals XLR balanced cables. This is because the 100% shield is only used as
a shield and is not part of the signal or return path. The signal & return
conductors are run as a twisted pair in the center of the cable, which
further fights unwanted noise through common mode noise rejection. This
extra quiet cable lets you hear the breathtaking details with the immediacy
of the original live performance. This is the exact same design that has
made our Model #470 Silver cable so popular. And, the #433 is also
available with XLR balanced connectors. Every #433 cable is hand-tested &
inspected by Granite Audio President Don Hoglund, and comes with his
initialed inspection card attached to the attractive packaging. The #433
will give 90% of the ultimate performance of the #470 at about 50% of the
cost. That's value.

Use this link to view a larger 215kb photo of the #433 Interconnect.

Large 433 Photo

@@@ Please contact us direct for any questions or to buy the Cables
contact us at [email protected] or call us at 215-953-9099 @@@

More about Continuous Cast Silver & Copper.

The most important factor in cable design is the quality of the conductor.
The introduction of Continuous Cast Silver & Copper allows the creation of
virtually perfect conductors. A heated mold forms conductors of nearly
perfect structure, with flawless, mirror-like surfaces, and high flexibility
and great fatigue and corrosion resistance.

The grain (crystal) structure of metals has always been a limiting factor in
cable design. Gases and solid impurities collect at the grain boundaries,
forming non-linear (diode) junctions. These non-linearities cause the
harsh, grainy sound quality of many cables.

A one-meter strand of drawn silver or copper wire, 0.3mm in diameter,
consists of from 50 to 40,000 individual crystals (depending on the quality
of the silver or copper). Since no conductor is absolutely pure, each
crystal boundary becomes a diode, adding its own non-linearity (however
weak) to the signal.

The Continuous Casting process eliminates this source of distortion by
eliminating the grain boundaries. In Continuous Cast cables, each crystal
is 125 meters long. This means that, even in long cables, there's never
more than one crystal junction per strand.

The single-crystal structure permits unimpeded signal propagation. The
result is an extremely neutral sound with grain-free, extended highs that
are open, airy, and detailed. This improvement is apparent throughout the
full frequency range, even down to the bottom end, whose weight, space, and
air are fully reproduced.

@@@ Please contact us direct for any questions or to buy the Cables
contact us at [email protected] or call us at 215-953-9099 @@@

Available from:
Quest For Sound
2307-R Bristol pike
Bensalem Pa 19020
215-953-9099
www.questforsound.com
email- [email protected]