PAIR OF AUDIOQUEST SUB-1 INTERCONNECTS SUBWOOFER 3M 10' CABLE RCA GROUNDED BOX

Call them New OEM Audioquest Interconnect
The Sub-1 are at the top of the Audioquest Hierarchy
Matched Pair of 10 Foot (3m) Cables in Original Box
As perfect as a gently babied piece of kit can be... 10/10
Each end has a Single RCA Male Connector
Triple Shielded with Chassis Ground Wire
Designed and made specifically for subwoofers
(works with other Hi-End Audio components)

2 Matched Cables Included (only one box)

Do Your Research
Compare to others listed and come back here to purchase
You will be delighted. Honest.

From Audioquest:

SUB-1 uses three solid 2.5% Silver conductors inside PE Air Tubes. Solid conductors eliminate strand-interaction distortion. PE Air Tubes minimize information smearing caused by any solid or foam insulation. Three conductors insure optimum performance, single-ended (RCA plugs) or balanced (XLR plugs). A 100% coverage shield insures noise-free performance. Silver-plated plugs are welded to Sub-1 using 8,000 amperes.

Silver-Plated Copper (SPC) always provides superior performance for video and digital audio. Unfortunately, when used for full range analog audio, the discontinuity of plating silver over copper causes high frequencies to sound edgy and harsh. However, when used only for subwoofer frequencies, SPC's "artificial edge" actually enhances the articulation and intelligibility of low frequency information. Do not use Sub-1 as a full range audio cable.

DIRECTIONS: If you hear noticeable hum in your system after connecting your subwoofer, please attach Sub-1's little extra tails. Some equipment has a ground (GND) connection on the back-panel, if not, attach the little spade lugs to any screw on the equipment chassis of both the source and the subwoofer.