Darwin Cable CompanySilverusedDarwin Cable Company Silver Phono Cable 1m RCA to DIN w GroundDarwin silver phono interconnect cable with ground cable. Wonderful cable to connect to your turntable. With the separate ground wire to connect to your phono stage or preamp. Used, in the excell...100.00

Darwin Cable Company Silver Phono Cable 1m RCA to DIN w Ground

Listing ID: lis89d0e Classified 
 Listed  · 105 Views

0 Watchers

Items from this seller

Time Left: None

This listing has ended.

Condition
7/10
Payment methods
Ships fromCary, NC, 27513
Ships toUnited States
Package dimensionsunspecified
Shipping carrierUSPS
Shipping cost$15.00
AverageResearch Pricing

Darwin silver phono interconnect cable with ground cable. Wonderful
cable to connect to your turntable. With the separate ground wire to
connect to your phono stage or preamp. Used, in the excellent condition.
It is the same cable as the regular silver cable, but the phono cable
has different skin jacket for better shield and separate ground wire to
connect between phono stage or preamp.

It has two very small AWG
silver wires that are in huge Teflon tubes, those are hand wrapped with
Teflon tape, which has hand wound copper foil over that.

I
am selling, unfortunately, as it doesn't work well with my suspended
table. I am not able to route the cable in such a way that it doesn't
interact with the suspension. For a non-suspended table, or heavy
suspended/damped table, it would be perfect.

This cable original came as an RCA-RCA, and I had Dave from Cryo-Parts add the DIN connector for me so the DIN is not original Darwin Cable Company parts. Dave does very good work though.

The current Truth II phono cables from Darwin are $1395 for a 1m pair with ground cable.
I did have a bit of hum with my AR-XA turntable when trying out this cable, but I hadn't finished grounding the T-Bar to the phono preamp. As you may well know, there are lots of influences in noise floor and good grounding/experimentation as well as system synergy is the most important thing. But I just wanted to highlight that with my system I had some hum with this cable. Had it worked for me I would have gone through some experimentation about grounding schemes with the motor and t-bar as well as the cable routing to avoid parallel paths with AC cables etc. 

No questions have been asked about this item.

Ask the seller a public question

You must log in to ask a question.

Return Policy

Return Window

Item can be returned within 3 days of receipt.

General Terms

Items must be returned in their original condition, with all included packing materials and no signs of use. Buyer assumes responsibility for all shipping return costs unless the item was not received as described.

Refunds

Buyer will receive a full refund in the original payment method less any shipping charges.