Balanced Audio Technologies BAT REX Preamp Just Serviced @ BAT

I have my BAT REX Pre amp up for sale.  Just back from being fully serviced by Vladimir at BAT with a clean bill of health.   Vladimir did a complete check on both the control and power module and ran software updates on both modules.  He said the units are operating at factory specs.  This also has the Six-Pak Option.  In May 2013 I purchased new 6H30 DR tubes for the control module and a complete tube replacement kit from BAT for the power module.  All tubes have less than 300 hours of use and are still in good operating condition. Also, I have a complete set of spare tubes for both the control and power modules (see photos).  I have rated the units at 8 just to be conservative; there is one mark (see pictures) on the control module which is minor but wanted to disclose.   I have the original shipping boxes + new outer boxes for safe shipping.  This will come with the remote, spare fuses, full set of spare tubes (both modules) and spare nuts for the covers. 

I would consider a partial trade for an Atma-Sphere MP-3 preamp or an Allnic L1500 preamp.

   
Specifications Description: Two-chassis, fully balanced, tubed, remote-controlled preamplifier with switchable absolute polarity. Tube complement: eight 6H30 in control module, two 5AR4, four 6C19, two 6H30, two 6C45 in power module. Inputs: 5 XLR. Outputs: 2 XLR (main), 1 XLR (tape). Volume-control resolution: 140 steps, 0.5dB each. Frequency range: 2Hz –200kHz. Maximum gain: 17dB. Maximum output: 50V. Distortion at 2V output: 0.005%. Noise: –100dB unweighted. Input impedance: 100k ohms minimum. Output impedance: 200 ohms. Power consumption: control module, 220VA; power module, 250VA.
Dimensions: Each module: 19" (485mm) W by 5.75" (145mm) H by 15.5" (400mm) D. Weights: control module, 40 lbs (18.2kg); power module, 36 lbs (16.4kg).