Sunny Components Inc,
Tue, Wed, Thur, Fri 10.00am-6.00pm.Sat-10am-4pm Closed on Sunday and Monday.
1370 E Cypress St Ste D,E Covina CA-91724 USA
Tel: 626-966-6259. Fax: 626-966-5467. Cell: 626-975-1353.
Email: [email protected]
Home theater website: www.sunnyaudiovideo.com
We Welcome Brinkmann Source products. Turntables and DAC's.
Some of the finest products
built in America & Europe, combined with the finest service and
know how and expert setup from Electrical power to the finest Audio
stands, electronics speakers turntables and streaming. We stock, install
and configure Roon and MQA.
are reference dealers for CH Precision, Brinkmann, Jeff Rowland, Bryston audio and
home cinema, MSB, Meridian Dacs, Amplifiers and streamers, NAD &
Speakers from Stenheim, Vandersteen, Egglestonworks, Vivid Audio, KEF, Aerial acoustics, Dali, Avantgarde and Martin Logan
Turntables from Brinkmann, Technics, EAT, Rega, Dali, Rel, Rega.
Audio stands by Harmonic Resolution Systems Salamander, Target, Quadraspire.
This Sale is for 1 each P3000HV Pre-Amplifier. Available in either Silver or Titanium.
We are taking offers on this Sale !
The P 3000 HV is the audiophile High-End
preamplifier of the series, and represents the universal control centre
for a High End Stereo system consisting of HV separates. It is equipped
with unique, newly developed technologies and innovative circuit
designs. Its measured results, specification and sound quality represent
the limit of what is physically feasible. The components and materials
employed are uniformly of top quality, without any hint of compromise,
and the workmanship of the case sets standards which are unmatched even
by much more expensive equipment. The P 3000 HV’s uncompromising design
is of symmetrical double-mono construction. Both balanced and unbalanced
sockets are available as outputs. There are four balanced inputs, input
No. 4 can be operated in surround (pass-through) mode in order to use
the power amplifier for the front channels of a surround decoder. The
analogue and digital mains power supplies are completely separate from
each other, and even feature separate mains sockets.HV-Link (HV data
bus), LAN socket, trigger input, RC-in for E-2000 and an ground terminal
are also present.
have developed an analogue signal processor module which not only
offers tone and loudness functions operating separately for each
channel, but also features three narrow-band parametric equalizers which
are capable of effectively damping room resonances in the range from 20
Hz to 500 Hz. The net result is that superb sound quality can be
obtained even in difficult rooms.
The P 3000 HV is equipped with a
high quality headphone amplifier with dual current capability and is
supplied complete with the F 3001 infrared remote control unit. Upon
request the P 3000 HV can be fitted with High-End phono preamplifiers,
which possess different circuit topologies for MM or MC pick-up systems.
In the ingenious overall circuit design of the HV
(= High Voltage) series – developed in-house by T+A – all the amplifier
stages operate at much higher operating voltages than usual: in the
preamplifier the figure is up to 100 Volt, in the power amplifier up to
360 Volt. In a similar manner to valve amplifiers, the actual modulation
of all the stages can be kept very low. Only a very small percentage
(less than 20%) of the possible excursion of the amplifier transistors
is used, thereby virtually eliminating the curvature (non-linearity) of
that characteristic. Additional measures for improving the linear nature
of the voltage amplifier stages are also employed. In addition to
outstanding linearity, the high operating voltages employed offer the
advantage of extremely wide dynamic range. We have developed this unique
technology for use in all the HV-series machines, since the tremendous
sonic improvements which it makes possible can be exploited in the
output stages of source devices such as the MP 3000 HV multi-source
player as well as in preamplifiers and power amplifiers.
The connector section on the back panel provides impressive evidence of
the P 3000 HV’s uncompromising design and symmetrical double-mono
construction. The channels are kept consistently separate. The
preamplifier circuit boards are of exact identical construction, and are
located under the case top cover; this layout eliminates
electromagnetic influences. The circuit boards are housed in their own
compartment made of thick-walled (10 to 15 mm) aluminium plates, and are
completely separated and shielded from the mains unit and power supply
in the bottom section of the case. The circuit topology is based on a
differential cascode amplifier with hand-selected audio J-FET
transistors. All stages are of completely discrete construction with-out
op-amps (operational amplifiers). Their linear nature is not derived
from “hard” negative feedback, as in the case of standard op-amps, but
from the quality of the circuit topology and the components employed,
which are carefully selected and adjusted. For this reason virtually no
overall negative feedback is required. T+A HV technology enables signals
up to 80 Vss to be processed without distortion – a value which is
unique for a transistor preamplifier.