Emerald Physics CS2P Reduced

Emerald Physics CS2P in perfect operational condition, but fair cosmetic condition due to many small nicks (mostly on the speaker rears and rear of speaker bases) because speakers were not properly protected when shipped to me.  I have touched up the nicks.  Luckily, there are only a few minor defects on the speaker faces.  I have taken many photos during a bright day with the flash on, so these show worst case.  Anyway, from a few feet away, the speakers look fine from the front.

The speakers will come with original cartons, instructions, passive crossovers with 2 sets of jumper speaker cables and the DSP 2.4 crossover/equalizer module.
So you will have several options for powering the CS2P. 

Use one stereo amp with single wires to the passive crossovers and jumper cables;
Use one stereo amp with biwires with the included passive crossovers and jumper cables;
Use two stereo amps via the DSP 2.4 crossover/equalizer module with single speaker wires from the amps directly to the speaker binding posts and eliminating the passive crossovers;
I am also selling some Emerald Physics amplifiers that power these speakers very well.  I will give a package discount for buying the speakers and amp(s).
The speakers can be shipped ground, but because the cartons are so large, the dimensional formulas kick in making it very expensive.  I checked and you are looking at $400 to the west coast not including the bases and crossovers.  If you want them shipped, I will definitely pack them well for safe shipping. I am setting the cost flat at $400, email me your zip code and I can give you a quote.

Or, if you are located in or around Illinois, I can deliver them for a nominal fee. Southern Wisconsin, Chicago, NW Indiana, Indianapolis, St Louis are all less than 3 hours from me.  I'd even help set them up!
You pay shipping or delivery or local  pick-up;  I'll cover paypal.

The CS2P is the upgrade for our first speaker, the revolutionary CS2.
The CS2 required biamping with 2 amps to work. The new CS2P is designed
to be an upgradable solution and you can start with Single amp
operation. Later on add our new DSP 2.4 digital processor/crossover and
extend the 40Hz bass to 24Hz as well as flatten the rest of the speakers
frequency response out even more than possible with a passive
crossover. Finally unhook the outboard passive crossover and add a
second amp to biamp the CS2P for ultimate performance.

Dimensions

• Height: 50.5 in. Width: 22 in. Depth - Baffle: 3 in.
• Depth: 16 in. including bass
• Net Weight: 80 lbs each

Type 2.5-Way, open-baffle, Passive, Dynamic Loudspeaker with optional biamp capability



Dipole below 1000Hz, Monopole above 1000Hz



Controlled directivity design 80˚ radiation angle



Impedance 4 Ohms



Treble Driver One 1 inch Emerald Physics exit compression driver



12 inch diameter Treble waveguide



Bass & Midrange Two (2) 15 inch Drivers - pulp fiber cone



Sensitivity 93 dB 2.83V @1M @ 1kHz with single amp operation



Crossover External Passive Network. Upgraded Special Edition crossover option available



Treble 1000Hz Linkwitz-Riley 2rd Order



Bass 1000Hz Linkwitz-Riley 4th Order



Frequency Linearity 40Hz - 20kHz +/-3dB from target curve