Audio Research Reference 610t Monoblock Tube Amps

This ad is for the monster

Audio Research Reference 610T Monoblock Power Amps!

When the Reference 600 Power Amplifier was introduced in 1995 it set a new standard for High Definition® in music reproduction. In every meaningful category, the Reference 600 - 300 amplifier series remained at the pinnacle of audiophile performance. Now the REF600-300 legacy continues with a new flagship from Audio Research: the Reference 610T monoblock.

Like its predecessors, the 610T monoblock is based upon a push-pull, fully balanced vacuum-tube circuit using 6550C output tubes (16 in all). But unlike the earlier models, the 610T uses two 6550C driver tubes, each controlling a bank of eight output tubes operating in unison. Input gain is provided by two 6N1P dual triodes and a 6H30 follower. This means fewer tubes to replace, and a much simpler biasing system: two bias adjustments instead of the 16 required in the REF600 series. Power output is rated at 600+ watts into 4, 8 or 16-ohm loads. Projected tube life is approximately 2000 hours.

Power supply energy storage has been increased to a whopping 1000 joules, with extensive film-cap bypassing of all electrolytics. In addition, interstage coupling caps are the new proprietary types first used in the REF3 preamplifier. Power-supply rectification is solid-state, while a total of six regulators are used: there is tube regulation of the input stage, with five additional solid-state regulators. The massive, custom output transformer is an ultra-wide-bandwidth design allowing a high damping factor and excellent current delivery. And, 50% coupling of the output-stage cathodes to the transformer yields both higher efficiency and better sound than conventional pentode or triode operation. Input is balanced only, with separate output taps for 4 - 8 -16 ohm speaker loads.

With the 610T, we decided to rethink the chassis from the ground up. Unlike previous Reference amplifiers that required abundant floor space and multiple fans for cooling, the 610T is a striking vertical design with tubes projecting above an anodized top plate. Dimensions are 14"W x 22"D x 21"H. The advantages of this design allow easier, next-to-speaker installation, silent convection cooling and better weight distribution. The "tower" chassis configuration (hence "610T") houses three different levels of circuit function. At the lowest level are the power and output transformers; on the second level are power-supply storage and regulation; and on top are the input and output tubes. A ventilated top cover with quiet Pabst fans is optional for CE compliance (these run off a 12V D.C. supply jack at the back of the chassis). Most owners will want to see the tubes in all their glory, and enjoy the benefits of silent convection cooling.

On the front of the 610T is a vacuum-fluorescent, multifunction display screen like that used on the REF3. The screen is addressable either via front-panel knobs, or by handheld remote. A variety of useful functions can be displayed on the screen: seven levels of illumination, including off; bias measurements for each output tube; A.C. line voltage level; logarithmic, scalable power output (0-10, 0-30, 0-100, 0-300, 0-600 watts); and total hours of tube life accumulated.

In addition to its innovative architecture and owner-friendly functionality, the REF610T sets new sonic standards as well. Just as the REF3 preamplifier provides remarkably clear sonic improvements over its predecessor, the REF2MKII, the improvements of the 610T over the older 600MKIII series are just as great, and of a similar quality. Transient speed, dynamic impact, soundstage focus and liquidity of detail are all remarkably improved. You will not have previously experienced a vacuum-tube amplifier capable of this level of resolution and control over any loudspeaker system. From massive dynamics to subtle nuance, solo voice to massed chorus, the 610T will likely never meet a commercial recording it can't handle with aplomb and deliver with musical passion - especially when driven by its Reference partner, the Reference 3 Preamplifier.

More information here: http://www.arcdb.ws/REF610T/REF610T.html

Great review here: Issue 177

This unit was just taken in trade, and is in good condition, including box and remote. They’re about an 8/10 cosmetically. The tube set has about 1000 hours on them.

We’re dealers for Audio Research, so we’ll be able to help and support this product moving forward.

It is currently available for auditions in our store in San Diego, CA. 

Who’s “Alma Music and Audio”?

We’re a hi-end audio store in Southern California, set in beautiful San Diego. We do NOT operate by appointment, so you can stop by our store anytime, browse the LP racks (2000+ and counting!), and enjoy our rooms set up with great gear from some of these brands:

Aqua Hi-Fi - Audio Research - Audioquest - Audionet - Audiopax - Auralic - Aurender - Bergmann - Brodmann - D'Agostino - darTZeel - Devialet - DEQX - ELAC - ENIGMAcoustics - Evolution Acoustics - Hegel - iFi - Innuos - IsoTek - Kii Audio - Koetsu - Kronos - Kubala Sosna - Kuzma - Larsen - Linn - MSB Technology - Music Hall - Ortofon - Solid Steel - Sound Galleries Music Server - Technics - Wharfedale - Wilson Audio - YG Acoustics

We prefer payment to be made by check, cash, or money order. Credit cards and PayPal OK, through our website [hint - free shipping in the US!] If you’re in CA, there’s also an 7.75% sales tax.

We’ll ship worldwide, please contact us for a quote to your destination!

We’d love to hear from you, so send us your questions, inquiries, orders, etc to: [email protected], or call us at (619) 243 4924, or (619) 243 6615.

Thanks for looking!