ad is for 1 x Klimo Labor Beorde turntable with Bliant 13" arm included
and full size matching power supply (33rpm and 45rpm) set for 120 volts. Retail
is $20000.00 USD for this combo.
Comes with belts, full sized external power supply set for 120 volts. I am
including at my asking price an Ikeda Sound Labs cartridge that retails at
$10000.00 USD. If I do not get my exact asking price than I will NOT include
the cartridge. Retail on the this combo is $30000.00 USD. Many reviews on the
cartridge. The cartridge has approximately 50 hours on it and the table is 2
ABOUT THE KLIMO BEORDE (from the Manufacturer):
The special shape of this record player and the materials used have the objective
of reducing the physical phenomena caused by unwanted resonance. It was decided
to reduce and, if possible, eliminate the base, which in almost all record
players currently available has a large surface area and is often the cause of
high resonance which has a very negative effect on the sound quality of the
All the parts of this record player, the structural parts as well as the minor
parts, are extremely precise and have been manufactured using the most
effective materials in their field.
The tolerance levels of the mechanical parts are incredibly low and the
calculations and checks for the resonance were carried out in accordance with
very sophisticated programs.
The motor is monitored by two electronic cards: the first card controls the
speed electronically using a quartz which stabilizes the frequency of the mains
power supply while the second card reduces the motor vibrations by means of
electrical adjustment of the phases of the motor itself.
TYPE: Magnetic levitation (self lubricating brass bearings)
THRUST-BLOCK: Magnetic levitation with absolutely no friction or noise, no wear
and tear over time
MOTOR: Synchronous 12+12 pin motor, powered and controlled with two circuits.
The first circuit is an electronic circuit consisting of a quartz oscillator
which synthesis the motor operating frequency. This constant-frequency signal
is amplified by a small transistor terminal and, using an output transformer,
pilots the power of the motor.
Ikeda Kai Cartridge Info;
• Type: MC cartridge
• Output Voltage: 0.19 mVrms (1kHz 35.4mm/sec., at 45°peak)
• Coil Impedance: 2.5 ohms (1kHz)
• Appropriate Stylus Force: 1.8 grams ±0.2 grams
• Frequency Response: 10Hz ～ 45kHz
• Channel Separation: over 27dB (1kHz)
• Channel Balance: within 1.0dB (1kHz)
• Stylus Chip: Micro-ridge Solid pure Diamond
• Cantilever: made of Boron.
• Top Panel: made of the strongest Titanium
• Weight: 11.5 grams
• Compliance: 7 x 10-6cm/dyne
Local pick up in Whitby or shipping is set at $200 in Canada and the USA.
Paypal fees are set at $170.00 or you can do a direct wire transfer into our
account at no additional charge. International buyers must pay via direct wire transfer.
PARTIAL DIGITAL TRADES CONSIDERED AND PRICE IS AN ALL IN PRICE EXCEPT SHIPPING COST.
No questions have been asked about this item.
Ask the seller a public question
You must log in to ask a question.
Returns are not accepted on this item.