Channel Islands Audio E-200S

Save $500 on E-200S!

Specifications

Power Output: 200 watts per channel @ 8 ohms (both channels driven)
400 watts per channel @ 4 ohms (both channels driven)
THD + Noise @ 1kHz: < .02% Max before clipping
< .006% at 1 watt
Phase Error: < 3° (20Hz~20kHz)Input
Impedance: 100k ohms
Gain/Input Sensitivity: 26dB/2.0V RMS (standard version)
32dB/1.4V RMS (high gain version)
Output Impedance: < .035 ohms (20Hz~20kHz)
Operating Voltage: 120V Model (95~132V AC) 6A Mains Fuse
240V Model (185~260V AC) 4A Mains Fuse
Power Consumption: < 0.5 watts (standby), 32 watts (idle), > 90% efficient at rated power
Dimensions: 14.0”W x 2.75”H x 10.0”D
Weight: 8.5 lbs. (actual), 10 lbs. (shipping)

Owners Manual

Features

• Flat frequency response and phase into any conventional speaker load
• Low distortion which is flat vs frequency
• Ultra low output impedance for excellent control of the loudspeaker
• High efficiency, which results in lower power consumption, low operating temperature, and high reliability
• Compact & light weight package

Power Management

The internal design of the amplifier consists of a power control circuit consuming less than a 1⁄2 watt of power. When turned on, this circuit feeds dual mono switched-mode power supplies… one for each channel. The on/off function can be controlled by the front panel switch or via the 12V trigger input on the rear panel.

Audio Circuit

Input signals are connected via rear panel mounted RCA (single-ended) or XLR (balanced) jacks into individual differential pre-stage circuits with on-board regulation. Output of this circuit is then coupled to updated UcD Class D stages. These new & improved output circuits incorporate many advances found in the Hypex NCore technology.

Amplifier outputs are conveniently located on the rear panel. Speaker connections can be made in a variety of ways via the insulated 5-way binding posts.

The compact machined aluminum chassis provides heat dissipation for the direct-mounted power supply and audio output circuits. Due to the high efficiency of the circuits, the chassis will only be warm to the touch under normal conditions.

Protection

The E series amplifiers are equipped with a variety of fault protections including DC, over-voltage, and short-circuit. AC Mains Fuse protection is also provided and easily accessible above the power inlet.

5 Year Warranty

Enjoy peace of mind with our comprehensive 5 year warranty. Full service information is included in the product manual.