Classe CA-2200 stereo amplifier with no fees

Selling my Classe CA2200 stereo amplifier.. Served me very well but its time to try something else new.. I've owned it for about 3 years and believe I'm the 3rd owner.. I recently had it checked out by Classe as at one time I thought there was something wrong with it.. So off it went to Classe to get it looked at.. It turns out it was my DAC that was the issue and not the amplifier (that was an expensive mistake) .. Anyway, since it was there I asked if they can pop the hood and bench test it to make sure everything was working as it should.. There's a scratch on one side of the amp that was made by the previous owner.. He said it was caused from removing the amp from his audio rack.. I will try to get a good picture of it later on.. I have the original CA2300 shipping box that I will use to ship this amp in.. I ship with FedEx with signature required.. Insured.. Flat rate $75 will be added to the cost.. No PayPal fees.. Please allow 1 day to ship.. Specs below.. This is an awesome sounding amp !! I'm positive you'll enjoy it.. Very powerful at 200 watts and high current.. High bias class A.. Any questions send me an email and I'll answer fast.. Thanks for looking..
review -- http://www.soundstage.com/revequip/classe_ca2200.htm
voltage gain 29.1dB bandwidth

phase

155kHz (-3dB)
22kHz (-0.1dB)
< -10° (22kHz) sensitivity 1.4Vrms power/channel (continuous)
(120VAC line, 1kHz signal regulated to 1% THD + noise into resistive load, all channels driven) load (resistive) 8Ω 200W 4Ω 400W THD + noise (unweighted, 10Hz - 500kHz bandwidth, 1Vrms/1kHz input) load (resistive) none 0.002% 8Ω 0.003% 4Ω 0.005% noise FFT noise floor peaks all below –95dBV
(with terminated inputs) S/N ratio (relative to 1kHz sine wave full level output into 8Ω) 108dB