Crown Studio Reference II – Audiophile Stereo Amplifier [Template]

This Crown Audio professional studio stereo amplifier
is in mint condition, never rack mounted- original one owner. Audiophile
quality sound reproduction, solid performance, quiet cool operation at all
volume levels, live-like crisp bright sound and extended clean bass punch.

$1650.00 each- Plus Shipping Costs- contiguous
48 states.

Specs-

·  Note: All
measurements apply to amplifiers in stereo mode with 8-ohm loads and an input
sensitivity of 26-dB gain, 1-kHz at rated power unless other otherwise
specified. Specifications for units supplied outside the U.S.A. may vary
slightly at different AC voltages and frequencies.



 

·  Output Power
(Maximum average power at 1 kHz with less than 0.02% THD):

·  Stereo Mode with
Both Channels Driven:

·  Studio Reference 2:
360 watts into 8 ohms, 565 watts into 4 ohms. Bridge-Mono Mode:

·  Studio Reference 2:
1,145 watts into 8 ohms.

·  Signal-to-Noise:
(A-weighted) At 26 dB gain with 8 ohm load.

·  Studio Reference 2:
Better than 117 dB below rated power.

·  Total Harmonic
Distortion (THD): Less than 0.02% at rated power. Intermodulation Distortion
(IMD): (60 Hz and 7 kHz, 4:1):

·  Studio Reference 2:
Less than 0.005% from full bandwidth power to 36 watts rising linearly to
0.025% at 36 milliwatts.

·  Load Impedance: Safe
for all types of loads. Rated for 4 to 8 ohms in Stereo, 8 to 16 ohms in
Bridge-Mono mode, and 2 to 4 ohms in Parallel-Mono mode.

·  Input Impedance:
Nominally 10 k ohms balanced and 5 k ohms unbalanced.



 

·  Controls: Enable,
channel 1 and 2 level controls, stereo/mono (Stereo, Bridge-Mono,
Parallel-Mono), ground lift switch, input sensitivity switch (0.775 V or 1.4 V
for standard 1 kHz power or a 26 dB voltage gain), meter on/off switch, dynamic
range/level meter switch, reset switch.



Connectors:

·  Inputs: Balanced
1/4-in. phone jacks on chassis and female XLR connectors on standard PIP
module.

·  Output: A pair of
color-coded dual binding posts for each channel.

·  PIP: Standard back
panel PIP connector.

·  AC Line: 3-wire male
connector with 5 ft. cable.

·  Dimensions: 19 in.
(48.3 cm) standard rack mount width, 7 in. (17.3 cm) height, 16 in. (40.6 cm)
depth behind mounting surface and 2.74 in. (7 cm) protrusion in front of
mounting surface. Approximate Weight:

·  Studio Reference 2: 56 lbs., 2 oz.
(25.5 kg).