Bellari Audio MT-502

                                       Bellari MT502 Matching Transformer



This step-up transformer is in very good to excellent condition w/low usage.

There are no scratches or digs on this step-up transformer.

No hum while I had this connected to my Michel Gyro w/SME arm sound very open
w/proper MC cartridge load 50-100 ohms.

I upgraded to a Hana MC cartridge and need a suggested >400 ohm impedance
load. That’s why this is up for sale.

Please read the specs before buying.  

Spec:

I/ O Connectors:               RCA

Input Impedance:   50-100 ohms

Output Impedance:  50k ohms

THD     .02% @ 1KHz

NOTE: THIS GUIDE ASSUMES THE USER HAS A WORKING KNOWLEDGE OF AUDIO ELECTRONICS
AND PROPER SIGNAL LEVEL SETTING.

QUICK START OPERATION GUIDE.

DESCRIPTION/CONNECTION:

INPUT: RCA's for connection to your turntable with moving
coil cartridge.

OUTPUT: RCA's for connection to a phono preamp with RIAA
equalization.

LIFT/GROUND SWITCH: This switch connects or disconnects the
ground connection between the INPUT and OUTPUT RCA's this might be useful for
reducing ground loops. SET THE SWITCH IN THE POSITION THAT SOUNDS BEST.

PREFERENCE A/B SWITCH: This switch sets the input impedance
level for your cartridge. PREFERENCE A is the higher impedance level and
PREFERENCE B is a lower impedance level. Again it is best to set the A/B
PREFERENCE switch to what position sounds best.

GROUND POST: For connection of your turntables ground wire.