IDIOM SSPP-1 Passive Pre amp with Remote... SALE [Template]

  SERIES SHUNT PASSIVE PREAMP WITH REMOTE

* Black Face Plate unit.   

* Exceptional Passive Preamp with Remote Control

*Developed & Assembled In The United States 

 *Components of only the highest quality

        Input signal passes through one very high quality 1% Caddock film  Resistor 

        OFC Gold Plated  RCA'S 

        Attenuation via a motorized ALPS Blue Velvet Pot. to ground

        Mundorf PTEE gold/silver wire...One of the Best!

        IR Volume Control Board fully isolated from the audio signal path

        Protected  from external RF

        Cardas solder

        Volume adjustment via remote is indicated by corresponding LEDs on the front panel.

 *Achieves a smoothness, detail, and natural openness comparable to equipment    found at a much higher price point.

Background:

With over 40 years experience, both professionally (as a designer and manufacturer of high-end audio equipment), and in my personal life as a passionate high-end audio hobbyist, I have been building and modifying audio equipment and loudspeakers, and actively participating in the audiophile community. About a year and a half ago, a few audio friends expressed frustration at their difficulty finding an affordable preamp of high quality, that also had a remote control, and asked if I could find a solution. I, too, had noticed a lack of solutions in my own attempts to assemble a high-quality, cost-effective system, as the preamps that performed well either had no remote, or were simply too expensive. I am retired and welcomed the challenge, and began developing a preamp that met our needs. After extensive research, feedback from my audiophile friends, and careful refinement, I arrived at a design that not only met, but greatly exceeded our expectations. The end result of our endeavors is so impressive, in fact, that we have decided to make a few units available to the audiophile community.

COMPATIBILITY:

A passive preamp works great in most systems. To function optimally, the source voltage should be approx. 2V with less than 150 Ohms impedance and amplifier input impedance should be greater than 33k, with an input voltage rating of 1.2V or less, for full output.

14 DAY RETURN: IF THE PREAMP DOES NOT MEET YOUR EXPECTATIONS. Must be in condition as received. 

Size: W6.5” x D10” x H2.5”

Included: PREAMP... 9V Power Supply, Remote and 2 AA Batteries

Only one available at the present time and subject to prior sale....Thanks