Mark Levinson ML436 Monoblock Amplifiers

This is a set of Mark Levinson ML436 mono block amplifiers. There are a few very minor cosmetic issues and with the age I would rate these an 8 condition however these were just recapped so the main power supply, regulator and main power board capacitors were replaced with brand new current production capacitors and the VG boards were also just reworked and updated by Mark Levinson so they have been cleaned and work and sound great. I have the original boxes but there is only one original manual. I can include a set of power cords but they are not the original cords.

I doubled the shipping based on weight and dimensions but I only charge actual cost and will refund any if over. Please inquire about shipping prior to making payment.

Description

Solid-state monoblock power amplifier with Madrigal speaker binding posts, one 3-pin XLR balanced input, two 1/8" minijacks for remote turn-on, one RS-232 port on RJ-11, Mark Levinson communication ports on RJ-45, and PHAST communications ports on RJ-45.d
Rated power output: (20Hz-20kHz, <0.3%. THD, FTC): 350Wpc into 8 ohms (25.4dBW), 700W minimum continuous into 4 ohms (25.4dBW), 1400W minimum continuous RMS power at 2 ohms (25.4dBW).
Frequency response: 20Hz-20kHz, ±0.2dB. Output impedance: ±0.05 ohm, 20Hz-20kHz.
S/N Ratio: better than -89dB (ref. 2.83V). Damping factor: >800, 20Hz-20kHz into 8 ohms. Power consumption: 100W in standby, 180W at idle. Current draw at rated output at 120V: 8.5A (350W into 8 ohms), 14.6A (700W into 4 ohms), 25.6A (1400W into 2 ohms).

Dimensions: 17.75" (455mm) W by 7.65" (194mm) H by 20.2" (518mm) D.
Weight: 85 lbs (38.6kg), 95 lbs (43.2kg) shipping weight.