Anthem Statement A2 Power Amplifier

Purchased new from an authorized dealer and used for about 3 years.  Amplifier was used to drive Goldenear Triton Reference Loudspeakers, which have built in amplifiers for the low frequencies.  This means that this amplifier always saw a very easy load.  The Statement amps have huge toroidal power supplies, overbuilt storage capacitance, very high signal to noise and modular construction.  They compare favorably to amplifiers that cost several times as much.  My only reason for selling is that I purchased JBL M2 studio monitors that are actively managed by Crown amplifiers.  Retail on this amplifier is $2500.  No scratches, works perfectly.   
GENERAL Inputs 2 Single-Ended, 2 Balanced, 1 Relay Trigger (3.5 mm Mono Jack)  Outputs 2 Pairs Speaker Binding Posts, 1 Relay Trigger (3.5 mm Mono Jack)  THD+N (200 W into 8 Ω) 0.001% at 1 kHz, 0.03% at 20 kHz IMD 0.0005% (CCIF, 225 W into 8 Ω)  POWER BANDWIDTH 10 Hz to 100 kHz (+0 -3 dB, 225 W into 8 Ω)  FREQUENCY RESPONSE 20 Hz to 20 kHz (+0 -0.15 dB), 5 Hz to 100 kHz (+0 -2 dB) INPUT SENSITIVITY 1.5 Vrms in for 225 W out into 8 Ω  INPUT IMPEDANCE 10 kΩ (RCA), 15 kΩ (XLR)   DAMPING FACTOR 360 at 1 kHz (ref. 8 Ω) S/N RATIO 120 dB, A-weighted (ref. 225 W) CROSSTALK -78 dB at 1 kHz VOLTAGE GAIN 29 dB SLEW RATE 30 V/µs SWITCHES Front Panel Power (On/Off) Rear Panel On/Off Modes (Trigger, Manual, Auto), Inputs (RCA, XLR)  POWER OUTPUT (Continuous RMS, 20 Hz to 20 kHz, <0.1% THD) Impedance                225 WPC into 4 ohms,  410 WPC into 2 ohms    DIMENSIONS Height 7-5/8 inches (19.4 cm) including feet Width Faceplate 19-1/4 inches (49 cm), Chassis 17-1/4 inches (43.8 cm) Depth 13-1/2 inches (34.3 cm) Weight (unpacked) 34 lb (15.5 kg)