T+A Criterion TCi2A Walnut finish.

Sunny Components Inc,
Tue, Wed, Thur, Fri 10.00am-6.00pm.Sat-10am-4pm Closed on Sunday and Monday.

1370 E Cypress St Ste D,E Covina CA-91724 USA
Tel: 626-966-6259. Fax: 626-966-5467. Cell: 626-975-1353.
Email: [email protected].
Store website: www.sunnyaudiovideo.com

Some of the finest products built in America & Europe, combined with the finest service and know how and expert setup from Electrical power to the finest Audio stands, electronics speakers turntables and streaming. We stock, install and configure Roon and MQA.

We are offering 1 pair of T+A Criterion TCI2A Active loudspeakers for sale

These speakers were purchased by me as my personal pair. Time for someone else to enjoy them. 

You can purchase the Matching T+A Preamplifier for $6995.00

 I have switched over to Meridian DSP7000SE speakers so these have to go.

The active electronic circuit is a complete unit of modular
construction, located at the rear of the loudspeaker cabinet
where its terminals are exposed. A metal plate carries the input
circuit board with the XLR and Cinch inputs, the mains socket,
the automatic power-on circuit, the room adjustment controls
and the stabilised voltage supply. The second level of circuit
boards houses the active crossover unit and all the signal
processing circuitry. The three output modules for the bass,
mid-range and high-frequency ranges constitute the final level.


Zero-loss, active crossover units.
Optimum coupling between the output stages and the loudspeaker drive units, combined
with outstanding damping factors, providing optimum control of the travel characteristics of
the speaker units.
Frequency response linearisation, expanded bass range and perfectly regulated cone travel
(motional feedback).
Compensated timing for each segment of the frequency band, optimum peak handling,
perfectly timed reproduction.
No transfer losses induced by loudspeaker cables.
Separate power amplifiers for bass, mid-range and high-frequency ranges for improved
dynamic response.
Low distortion, extremely low total harmonic distortion (THD).
Option of active compensation to match the listening room and speaker positions.
Specifications
Principle full active floorstanding speaker
Nominal output range 3 x 350 W
Peak output range 3 x 500 W
Constant power output (power supply) 450 W
Power bandwidth 0,1 Hz - 55 kHz
Damping factor > 600
Frequency response 20 - 45000 Hz
Bass drive unit 2 x 220 mm
Bass / Midrange unit 1 x 180 mm
High frequency unit Electrostat tweeter
Crossover frequencies 190 / 3500 Hz
Dimensions (H x W x D) 120 x 27 x 40 cm
Weight 60 kg
Finishes  walnut