BAT VK-P12 Tube Phono Stage

This was a customer trade.  It has been tested and works well.  It had one owner and was well cared for. It is in original packaging.  The face plate it custom, and I am optimistic I will be bringing in the matching VK-53SE preamp on trade along with a Rex 2.  
This is NOT the special edition, it is the original model but my understanding is it can be upgraded if you reach out to BAT. Wonderful phono stage. Obviously it is fully balance and an uncommon item in the used market.

Balanced Audio Technology VK-P12 Phonostage
Dual-mono construction, balanced inputs, vacuum-tube current sources, enormous energy reserves, and a massive power supply push the VK-P12 to the forefront of the world’s finest phonostages. VK-P12 uses the same amorphous core output transformers employed throughout Balanced Audio Technology’s premier line of phonostages Complementing the unit’s all-tube zero-feedback design, a unique Flying RIAA circuit maximizes accuracy, brings the benefits of fully differential operation to the critical equalization stage, and delivers standard-bearing fidelity to the original recorded signal. The end result is a circuit that unlocks hidden performance in virtually any cartridge.
BALANCED ARCHITECTURE
The VK-P12 is fully balanced from input to output. For the best possible performance, the phono cartridge should be used in a matching balanced configuration. Many turntables and tonearms allow for such a termination. In some cases, even if only RCA connectors are present on the arm, the cartridge can still be used in a balanced configuration by using a specially designed cable.
TEN-TUBE, ZERO-FEEDBACK DESIGN
The VK-P12 features an all-tube zero-feedback design that combines the benefits of balanced operation with complementary vacuum-tube current sources. Dual-mono construction and enormous energy reserves are matched by extensive flexibility in cartridge loading. Equipped with a new aluminum top cover, this incredible music instrument boasts high-quality input step-up transformers for greater flexibility in handling the lowest-output moving-coil cartridges as well as a Six-Pak of custom oil-filled capacitors in the output stage.
FLYING RIAA NETWORK
Among the benefits of the VK-P12’s differential RIAA network are ease of adjustment and improved common mode noise rejection. This circuit is also completely passive and has fewer components than a more traditional implementation. The ease of factory adjustment translates into improved matching of the RIAA curve to specification, with an RIAA error typically not exceeding 0.1dB! With the BAT Flying RIAA network, you can be assured that all of your records sound the way that the recording engineer intended.
VACUUM-TUBE CURRENT SOURCES
Vacuum-tube current sources further improve the linearity of any gain stage to yield a more open and textured sound than a simple resistor-based solution. In the VK-P12, dual 6SN7 vacuum tubes act as current sources for the second gain stage. They complement the inherent strength of vinyl playback in that the finest texture and harmonic structure of musical instruments are portrayed with greater delicacy.
SELECTABLE STEP-UP TRANSFORMERS
The VK-P12 features second-generation step-up transformers that provide as much as a 20dB improvement in signal-to-noise ratio in comparison to direct mode operation. This allows the customer to successfully use even the lowest output moving-coil cartridges. With up to 80dB of gain available, no signal is too small!

Inputs1x RCA + 1x XLR
Signal-to-Noise Ratio Direct (Low) – 45dB (High) – 60dB
Outputs 1x XLR
Set-up (Low) – 65dB (High) – 80dB
Gain at 1kHz Direct (Low) – 45dB (High) – 60dB
Polarity Switch Selectable – 0 to 180
Set-up (Low) – 65dB (High) – 80dB
Power Supply Energy Storage 140 joules
Cartridge Loading (Resistance ohms) Selectable from 100 to 47k
Power Consumption 150VA
Cartridge Loading (Capacitance pF) Selectable from 0 to 1000
Dimensions 19” x 5.75” x 15.5”
Tube Complement 4x 6922, 4x 6C45, 2x 6SN7
Weight 40 lb

You pay the shipping, I will pay the CC/PayPal feel.