Garrard/Lenco/Commonwealth IDLER POWER SUPPLY
Listed · 106 Views
This listing has ended.
Listings Similar to Idler Drive Turntable Power Supply
Time Left: Listing Sold
This listing has ended.
Condition | |
Payment methods | Contact seller |
Contact seller after sale to pay viaVISA/Mastercard, American Express, Discover, Certified check, Personal check, COD or Wire Transfer | |
Ships from | Kunkletown, PA, 18058 |
Ships to | United States |
Package dimensions | 14.0" × 19.0" × 5.0" (30.0 lbs.) |
Shipping carrier | UPS |
Shipping cost | |
Original accessories | Manual |
Average | Research Pricing |
Under the radar industrial power supply for running your idler drive turntable. I have two of these to run my massive Commonwealth 16A and 12D idlers. More wattage than any audiophile made power supply it can handle any turntable motor. Runs at 110 voltage in (USA). Switchable 110/220 volt AC output. Plus added in is the frequency amplifier (MOS03) to allow 60/50hz use. Voltage can be finely adjusted for the lowest motor noise. Frequency is super fine adjustment for true 33/45/78rpm speed control. So transcription idlers with no speed control can be used with spot on speed stability and constant control. LCD meter allows both voltage and Hz to be monitored.
A heavy industrial unit it it comes with a manual I may have the box but it was a generic box anyway.
Paypal or CC adds 3.2%. Shipping via UPS at my discounted rate.
No returns.
No questions have been asked about this item.
Ask the seller a public question
You must log in to ask a question.
Return Policy
Return Window
Returns are not accepted on this item.