FRITZSPEAKERS - CUSTOM BUILT LOUDSPEAKERS SINCE 1973!
THEY COME WITH A 30 DAY MONEY BACK GUARANTEE (LESS SHIPPING) IF YOU ARE NOT ABSOLUTELY DELIGHTED WITH THE PERFORMANCE OF THEM ON YOUR SYSTEM & ROOM ACOUSTICS.
SCANSPEAK DRIVERS WITH SERIES CROSSOVERS!
This model is a new less expensive version of my upgrade REV5 SE design and features a ScanSpeak ring radiator tweeter that has higher frequency extension with more air than the original ScanSpeak 9500 tweeter and also has upgraded crossover parts.
The cabinets are in a Cherry wood finish and the size is 14H x 8W x 10 1/2D. They have a ScanSpeak 5.5 inch Revelator paper cone Mid/Bass driver with good bass response down to 40 Hz and a ScanSpeak Ring Radiator tweeter that extends out to above 40 KHz These same drivers were used in several major name brand models that cost 4 to10 times $$ more!
SERIES CROSSOVERS- Check out the impedance & phase curves on these. Google any other loudspeaker & see if they have a Stereophile review & look at their impedance curves on the measurements page. Most name brand loudspeaker impedance curves look like a mountain range with large peaks & dips. Loudspeakers with Series crossovers sound more natural. My web site has more info on why Series crossovers work and sound much better than conventional crossovers.
Here's some copy and paste links to reviews of the original REV 5 model, this new version is now even better sounding!
Check out my other ads for different wood finishes that are available & go to my web site for links to 35 reviews of my loudspeakers from- The Absolute Sound, Part Time Audiophile. Enjoy the Music, Positive Feedback, Stereo Mojo, 10 Audio, Stereo Times, Sonic Flare and many others.
I can take PayPal and most credit cards for payment. I ship by FedEx to the lower 48 states and Canada. I can usually get a great 1 or 2 day air shipping rate to most other countries world wide. Contact me with your city and postal code for an overseas shipping quote.
Thanks for looking Fritz Heiler FritzSpeakers.com 310 379 8190
BTW- Series crossovers actually have variable crossover points. Conventional crossovers are basically mathematical equations that are separately calculated based on the impedance of the drivers used in the speaker. When music is playing though a loudspeaker, the drivers voice coils heat up and the impedance and other electrical parameters can change. A heated 8 ohm mid/bass driver coil may become 7 ohms, a 6 ohm tweeter coil may become 8 ohms (could be higher or lower depending on voltage & current), effectively changing the crossover points of each driver. The mid/bass could now roll off sooner (lower) and the tweeter could come in later at a higher frequency... or vice versa. This can result in an overlap or suck out between them.
With Series crossovers both of the drivers are in the same circuit and the crossover points fluctuate between the two drivers eliminating the peaks or suck outs of conventional crossovers.