Theta Digital Dreadnaught D 5 Channels

I have an excellent Theta Dreadnaught D amplifier. It is just like New but I cannot list it higher than 9 due to Audiogon's requirements because I have it for about 1.5 years. This amplifier is so good that does not need any explanation. The sound is so good, dynamic, rich, detailed and like live sound that you can listen for hours without harshness or irritation. You can read many online professional reviews. Below is the manufacturer specifications:
Analog Audio Inputs
1 Single-ended (RCA) per channel on each module.
1 Balanced (XLR) per channel on each module.
Input Impedance 47 kOhms. Single-Ended or Balanced, each phase.
Input sensitivity Mono or Stereo module:
Single-ended) 1.825V RMS input for 225W into 8 ohms.
Balanced) 1.825V RMS input for 225W into 8 ohms.
Mono Bridged module
Single-ended or Balanced) 1.825V RMS input for 500W into 8 ohms
Gain (Single-Ended or Balanced) 27.8dB.
Polarity (Single-ended) Non-Inverting.
(Balanced) Pin-2 = Positive, Pin-3 = Negative for Non-Inverting Output.

Analog Audio Outputs
One balanced output with 5-way binding posts per channel.
Modes/Processes Standby: Amplifier is ready to be turned on via front panel switch or remote trigger.
Overcurrent, D.C., and/or thermal protection: Amplifier will cycle.
Catastrophic D.C. or output stage failure: Amplifier will shut down.
Power Output Mono or Stereo Module
8 ohms: 225W RMS per channel with less than 0.05% THD from 20 Hz to 20 kHz:
4 ohms: 375W RMS per channel with less than 0.05% THD from 20 Hz to 20 kHz.
2 ohms: 500W RMS per channel with less than 0.05% THD from 20 Hz to 20 kHz.
Mono Bridged Module
8 ohms: 500W RMS per channel with less than 0.05% THD from 20 Hz to 20 kHz
4 ohms: 800W RMS per channel with less than 0.05% THD from 20 Hz to 20 kHz.
Frequency Response +0, -.5 dB 0Hz to 20 kHz, load independent.
Damping Factor Greater than 6000 at 100 Hz; Greater than 2000 at any frequency up to and including 20 kHz.
Signal to Noise Ratio 120dB referenced to rated output (A-Weighted)
Crosstalk -85 dB

Miscellaneous
Power Requirements 117V AC, 15A Slo BLo main fuse: 230V AC 8A Slo Blo main fuse; 50/60 Hz
Power Consumption Less than 1W at Standby; less than 80W at idle; 1500W maximum by 2 when fully loaded
Trigger Input 5 to 12V DC; Steady State.
Dimensions (W x H x D) 17 5/8 inches x 7 15/16 inches x 19 3/4 inches; 448 mm x 202mm x 502 mm