This is a fantastic 2 channel class D AMP delivering 200 w per channel. It would pair nicely with the NHT Controller I have listed. It sat in my HT rack in a non-smoking home for 3 years.
Power Output 2 x 200W RMS @ 8ohms THD+N <0.05% - all channels driven simultaneously
Frequency Response +/-0.5dB 20-20kHz
Dynamic range 112dB A-weighted @ full power
Damping factor 2000 @ 8ohms 100Hz
Peak current 35A
IM distortion (CCIF) 0.0005%
TIM distortion 0.003% Soft Clipping
•Intelligent operation with NHT Controller.
•Monitoring of amplifier status
•Amplifier control - on/standby/mute.
•Control of individual channel operation - on/off.
•Utilizes Ethernet infrastructure
•Phase-to-phase short. Phase-to-ground short. Under voltage. Thermal protection.
Rear panel connectors & components
•2 Single-ended RCA input connectors.
•2 Pair of binding posts for speaker output - banana spacing.
•12V Trigger input/output on 1/8" sub mini jacks.
•NHTBus connector on RJ45.
•IEC mains voltage socket
Front panel features
•2 Dual color LEDs for each channel indicating OK/Fault.
•Standby Touch Sensor.