Take this opportunity to purchase a very nice sounding amplifier and highly quality built in Germany at a very LOW PRICE. We are welcome for audition, please call first for appointment before arrival. Feel free to call us with any question you might have in regard of this amplifier.
Kelly High End Audio
Original owner trade in mint. condition of Octave MRE 130 tube mono block amplifier in black color as you can see in photo.
Here is what come with amplifier
1. Upgraded SUPER Black Box power supply
2. Upgraded factory tube ( much better than stock tube)
3. All original accessory and boxed.
4. Condition is like new and no issue what so ever.
In case you want to read latest review then please click into the link below.
MRE 130 Mono Amplifier - Ruler of the Sound
The MRE 130 mono amplifiers are push-pull power amps in pentode configuration, producing approximately 140W per channel at 2% THD. The MRE 130 monos are designed to reproduce the vast scale of a large orchestra in its entirety. From the deepest bass, to the highest note- all the musical information is conveyed without loss of dynamic details. Raw emotion, stunning detail and rich voices - the MRE delivers fireworks. There are power amps on the market which canâ€™t run because of the power they have, whereas the MRE 130 can sprint. The sum of all its sonic characteristics makes the MRE 130 a suitable partner even for the exalted Jubilee preamp.
OCTAVE power amplifiers have always set new standards. With the introduction of the original RE 280 stereo power amplifier, Andreas Hofmann left traditional power amp technologies far behind. With the MRE 130, Hofmann has gone one step further. While it has the same power management and optimized input stage as its stereo brother, the MRE 130 benefits from an innovative and enhanced output stage configuration. What is revolutionary about this new generation of amplifiers is that OCTAVE has employed the classic, yet almost forgotten, pentode configuration.
The classic pentode configuration was quite commonly used in earlier power amplifiers. It offered the benefits of reliability and a relatively high power output. From a modern perspective, its disadvantage was reduced dynamic stability and a high level of distortion. These effects are not a direct result of the pentode itself, but rather of the circuitry employed at the time. Andreas Hofmann has now developed a new circuit design that eliminates the drawbacks of the classic pentode configuration. This novel design involves the use of a second, separate power supply circuit for the auxiliary current required for the pentode mode of operation. The characteristics of this enhanced pentode circuit employed in the MRE 130 are virtually ideal from both a sound quality and an engineering point of view.
Power Output 130 Watt into 4 Ohm
Frequency Response 10 Hz - 80 kHz / Â± 0,5 dB
Total Harmonic Distortion< 0,1% at 10 Watt into 4 Ohm
Signal-to-Noise Ratio> 100 dB
Minimum Speaker Impedance2 Ohm
Gain / Input Sensitivity + 30 dB / 1 V