I am selling my Creek 5350 SE Integrated Amplifier with the optional Phono Stage (Creek Sequel 40 Mk2 Moving Magnet (MM) Phono Pre‑Amp). The amp new at retail was $1,500. The phono preamp, which was new when I added to the integrated about 15 months ago was (and still is) $200. I bought the integrated here on Audiogon. I had the amp checked out and cleaned up at Hawthorn Stereo in Seattle when I bought it ~1.5 months ago.
I am selling because I am wanting to try out a tube set integrated. I don't have much feedback via Audiogon, but I have 100% positive feedback on eBay (~400 transactions), and 100% positive feedback on Discogs (~30 transactions).
OTHER INCLUDED ITEMS:
(1) A pair of Silver Audio .5 meter interconnects instead of the standard metal jumpers are used to close the preamp circuit
(2) A 14 gauge shielded A/C power cable.
(3) Original remote control and operating instructions brochure
***Creek 5350 SE Integrated Amplifier***
Description: Solid-state integrated amplifier.
Power output: 85Wpc into 8 ohms (19.3dBW), 120Wpc into 4 ohms (17.8dBW).
Maximum current: >30A.
THD: <0.05%, 20Hz-20kHz.
Frequency response: 3Hz-25kHz, -1dB.
Power amp slew rate: >50V/µs.
Voltage gain: >50.
Input sensitivity (passive line): 525mV line-level input for 50W.
S/N ratio: >105dB.
Channel separation (line input at 1kHz): >55dB.
Moving-magnet sensitivity and impedance: 3.5mV at 47kW. MM S/N: >70dB.
Moving-coil sensitivity: 750µV at 1kW.
Power consumption at idle: <40W.
Power consumption at full power: 350W.
Dimensions: 17" W by 3" H by 11" D.
Weight: 18 lbs.
***Creek Sequel 40 Mk2 Moving Magnet (MM) Phono Pre‑Amp***
-Gain x100 (40 dB)
-10 Hz to 20 kHz +/- 0.5 dB
-Signal to Noise Ratio -- 80 dB
-Total Harmonic Distortion < 0.03%
-R1AA deviation +/- 0.5%
-Output 400 mV from 4mV input
-Input Sensitivity / Impedance/ Capacitance -- 4mV / 47K Ohm / 220pF
-Overload Margin 22 dB
-Suitable for medium to high output MM cartridges in the range of 3.5mV -- 5mV output