Emerald Physics 100.2SE SILVER

Emerald Physics 100.2SE Special Edition stereo power amplifier.
Box, Manual, Power Cord
NO issues, a few light scratches hardly noticeable

The 100.2SE is a 100 watts per channel stereo power amplifier with a class D output stage coupled to our custom Emerald Physics analog power supply.
The 100.2SE is an upgraded version of our 100.2. It uses upgraded caps, resistors, hand would inductors and a much larger power supply. The SE amp also replaces the polyester caps with polypropylene capacitors in 2 critical locations.
The SE version uses Nichicon KS series 15000uf/50V caps. We upgrade the output filter inductors. We use a larger toroid core size, which allows us to use fewer turns of a fatter wire to achieve the same inductance as we now have.
This will decrease losses and improve the damping factor by 15-20% over the stock amp. We upgrade the power supply bridge rectifier to use low noise ultra-fast-recovery diodes. The Special Edition amp delivers 20% more current that the standard model.

The 100.2SE has both balanced and single ended inputs as well as a mono switch that allows you to start with a single 100wpc stereo amp and end up with a pair of 275 watt mono amps that do over 350 watt peaks.
Initial users have been blown away with the sonics.Special Edition version of 100.2

Fully balanced design

100 watts RMS @ 8 ohms

150 watts RMS @ 4 ohms

275 watts RMS mono operation

450 watts in mono @ 4 ohms

2 ohm stable

Copper RCA & XLR inputs

Extremely efficient (~93%)

Digital amp with custom analog power supply

Upgraded caps, resistors and hand wound inductors

50% larger power supply than the standard amp

Copper binding posts

Made in USA

Shipping is 35.00 a flat rate
Lower 48