EmotivaXPA-200Emotiva XPA-200This unit is in great working condition with an Emotiva warranty in effect until 6/26/18.  Shipping is by the buyer.  Please note the units dimensional and weight data shown below. Topology:...375.00

Emotiva XPA-200 [Expired]


no longer for sale

This unit is in great working condition with an Emotiva warranty in effect until 6/26/18.  Shipping is by the buyer.  Please note the units dimensional and weight data shown below.

Topology:

Fully discrete, dual differential, high current, short signal path Class A/B.

 

Number of Channels: 2

 

Power Output (rated power; THD < 1%):

150 watts / channel; into 8 Ohms; both channels driven. 240 watts / channel; into 4 Ohms; both channels driven.

 

Rated Power Bandwidth (at rated power; 8 Ohm load):

20 Hz to 20 kHz + / - 0.045 dB.

 

Minimum Recommended Load Impedance:

4 Ohms (which equals one 4 Ohm load or two paralleled 8 Ohm loads).

 

Frequency  Response: 10 Hz to 80 kHz (+ 0 / - 1 dB).

 

THD + noise: < 0.02%

 

Signal to Noise Ratio (8 Ohm load):

> 89 dB at 1 watt (A-weighted).

> 110 dB at rated power (A-weighted).

 

Damping Factor (8 Ohm load): > 500

 

Speaker Output Connections:

Full-sized, 5-way binding posts; one pair per channel (two channels).

 

Power Supply:

90,000 uF of storage capacitance.

360 VA heavy duty toroidal transformer

Input Sensitivity (for rated power; 8 Ohm load): 1100 mV.

 

Gain: 29 dB.

 

Input Connections:

Unbalanced (RCA); balanced (XLR); one each per channel.

 

Input Impedance: 47 kOhms.

 

Trigger:

Trigger Input: 5 - 20 V (AC or DC); <10 mA input current required. Trigger Output: 12 VDC; can drive any load up to 50 mA.

 

Power Requirements:

115 VAC or 230 VAC +/- 10% @ 50 / 60 Hz (automatically detected and switched).

 

Front Panel Controls and Indicators:

Standby; push button (halo ring changes color to indicate Standby or On).

Status LEDs (four); blue LEDs illuminate for normal operation, red LEDs flashes during power-on or when a fault occurs; (may be disabled by rear panel Status LED switch).

 

Rear Panel Controls:

AC Power switch; rocker switch (switches AC mains power).

Status LEDs switch; small slide switch on left (disables front panel Status LEDs and dims. Standby button halo lighting).

Input selector; toggle switch (selects between balanced and unbalanced inputs).

 

Protection:

The XPA-200 is protected against excessive operating temperature, shorted speaker

connections, ground faults, and other common fault conditions.

 

Dimensions:

17” wide x 3.875” high x 19” deep (includes feet and binding posts).

 

Weight:

     31 pounds unboxed (37 pounds boxed)
Seller Information

lynnwill 

Last 12 months
All-time24100.0%

Member since May 2009

Items from this seller