Marantz 240 Marantz 240, needs repair, free shipping, reduced yet again
Listed · 550 Views
This listing has ended.
Listings Similar to Marantz
Time Left: None
This listing has ended.
Condition | |
Payment methods | |
Ships from | Rochester, NY, 14615 |
Ships to | United States |
Package dimensions | 25.0" × 16.0" × 10.0" (30.0 lbs.) |
Shipping carrier | FedEx |
Shipping cost | Log in to see price |
Average | Research Pricing |
Marantz 240 Power Amplifier--NEEDS REPAIR
I bought this power amplifier a few years ago and when I finally got around to trying it out I carelessly connected it to the wrong pre-amp inputs, and poof...it smoked and would not turn on. So I put it away and forgot about it until a few days ago.
As far as I can tell the amplifier is complete. The top screws are not original but do their job well enough. Its physical condition, in my opinion, and for its vintage age, is approximately fair, or perhaps a bit better. There is a dent in the lower left front corner, which I've straightened out to the best of my ability.
I don't think it would be difficult for a fairly knowledgeable person to troubleshoot the problem. As a matter of fact, I'm guessing someone with experience can figure it out from my description alone. At the very least, this amp should be a good parts unit.
Please refer to the photos. Thank you.
NEEDS REPAIR----SOLD AS-IS
RMS Power Per Channel 120 @ 8, 150 @4, 60 @ 16
Damping Factor @ Load Impedance >100 @ 8 ohms
Total Harmonic Distortion (THD) 0.1%
Power Bandwidth 5 Hz to 45 KHz
Frequency Response +0/-1.5 dB 2Hz to 100KHz, +/- .1dB 20Hz to 20KHz
Hum and Noise -106 dB
Signal to Noise Ratio -106 dB
Intermodulation Distortion (IM) 0.1%
Input Impedance 100K Ohms
Input Sensitivity for Full Output 1.5 V for rated output
Output Impedance(s) 4 to 16 ohms
Width 15 3/8
Height 5 3/4
Depth 9 5/8
Weight 28 lbs
Questions for the seller |
---|
Has amp ever been worked on ? I have the same amp and it is broke I might be able use it for parts. Give [filtered] #. My [filtered] number is [filtered]. It's on between noon and ten ET. I would have included it in the ad but the basic listing won't allow it.
Thanks for your interest. I did not buy it new, so I can't be sure it was not worked on. Judging from a careful examination inside, I'm pretty sure it has not been worked on, but I won't guarantee it.
I think it would be a very good parts unit. Let me know if you have any more questions.
|
Ask the seller a public question
You must log in to ask a question.
Return Policy
Return Window
This item is sold As-Is and cannot be returned.