This Rega Maia 3 Amplifier is in spectacular condition in all respects and I'd rate it at 85% cosmetically (very few very small areas where the paint has chipped) and 100% functionally. Sounds great, plenty of power and plays clear and true.
Solid body with little to no scratching. Super clean. No dents. Plastic on speaker posts show a little wear but are fully functional for spades or bare wire. I've used it with banana plugs which hold tight and solid. No original packaging but will be boxed appropriately. Comes with power cord.
Buy with confidence from a solid Audiogon citizen.
From Rega: The Rega Maia 3 is an 85 watt per channel high performance audio power amplifier housed in the Rega custom built extruded aluminium case. The amplifier has a fully protected output stage with DC and electronic thermal protection, and a power monitor for both transformers. High quality Evox capacitors have been used in the signal path throughout.
The Maia 3 uses the Rega "common base driver stage" circuit design. Rega used circuit modelling and listening tests to design this amplifier resulting in superb reliability and exceptional sound quality. Sanken 200w output transistors are used in a high current output stage and will drive the most awkward of speaker systems.
The power supply uses two generously rated toroidal transformers with 28,200mF of parallel connected smoothing capacitors, which will provide enough current to drive the hardest of loads.
85w RMS per channel into 8W
Rega Custom built extruded aluminium case
Dual Toroidal transformer power supply
200w Sanken output transistors
High thermal efficiency heat sink
System compatible with a gain of 28dB
Maximum input level 150mV @ 1kHz
Input sensitivity & impedance 206mV @ 24k Ohms
Power Output 85 Watts per Channel
Users Manual available via this link: