Rotes RB-1080 Rotel Amplifier

For sale is my Rotel RB-1080 amp.  Since new it has been used only seven months.  I planned on setting it up in a separate
room, but I down sized and have nowhere to set it up.  I take very good care of my audio gear and
you can not tell this one from a new one. 
This amp has been stored in my bedroom closet under a HVAC
environment.  Rated a 10/10 by audiogon
standards.  I have the manual, original packing material and stock power cord.  I love the way this amp sounds, lots of
detail.  The price new was $1,000.00 plus
tax.  This amp has XLR and RCA inputs and
a 12-volt trigger in and out.  For sale
at $395 plus shipping and insurance.

 Description:

 The RB-1080 rests close to the pinnacle of Rotel’s two
channel power amplifier offerings.  Power
output (200 watts per channel into 8 ohms) is extraordinary.  The Rotel-made toroidal transformer feeds
separate power supplies for each channel.  British BHC Slit Foil storage capacitors
provide quick charge/discharge times for instantaneous response to the most
demanding signal peaks.  Damping factor,
at 1,000, shows this amplifier’s unparalleled ability to lock onto the most
difficult speakers to precisely control diaphragm motion and give you superior
sound quality.  Heavy duty dual binding
posts encourage the use of the most advanced speaker cables while switchable
balanced (XLR) and unbalanced (RCA) inputs provide extraordinary system
configuration flexibility.  Front panel
heat sinks add a strikingly dramatic look.  Separate inputs and outputs for a 12 volt
“trigger” signals and a detachable AC cord make this amplifier well suited for
custom-installed systems with total remote-control capability.

 For the Information sheet and Owner’s Manual, check out the
below link:

  http://www.rotel.com/products/specs/rb1080.htm

 Specifications:

 Model RB-1080

Power Configurations:  2x200 watts

Watts/Channel:  All
channels driven, unbridged, 8-ohm load, 20 to 20k Hz, 0.06% THD

Total Harmonic Distortion (THD 20 Hz - 20 kHz):

    cont. rated power - 0.03%, maximum

    one-half rated power - 0.01%, maximum

    one watt per channel - 0.02%, maximum

Intermodulation Distortion (at rated power, 60Hz:7kHz = 4:1):  0.03%, maximum

Damping Factor (8 ohms):  1000

Input Impedance/Sensitivity:  1.5V, 32 kohms


Input Overload Level:  5V

Frequency Response:  15Hz-100kHz +0.5dB,
-3dB

Signal to Noise Ratio (IHF A):  116 dB

Power Consumption:  550 Watts

Dimensions (W x H x D):  430 x 139 x 400
mm, 17 1/8" x 5 1/2" x 15"

Front Panel Height:  127 mm, 5.0”

Power Requirements:  115
volts, 60 Hz

Weight (net): 16.7 kg, 36.8lbs