Tube Audio Design Hibachi Mono Blocks

In Pristine Condition - Excellent and Rare Find - Exceptional Value
SPECS & DETAILS # 205W RMS Clean into 4-Ohm speakers, 180W RMS into 8-Ohm Speakers # Best with speakers rated over 85db (higher is better), 2-Ohm to 16-Ohm # Perfectly Flat Frequency Response 5Hz-50kHz, -3db 2Hz-200kHz # Cutting Edge Design without feedback reveals recorded harmonic structures like a tube amplifier while maintaining solid state bass capabilities # Features Soft Clipping like tube amps # NO Coupling Caps, Directly Connected Part To Part for Zero Loss in Detail, Zero Phase Shift Blur # 0.7V-RMS input for full power (normal CD player line level output) # Easy to drive & match 46k Input Impedance # Small volume knob on each amp to balance the room and adjust the input sensitivity. (0.7V to 20V) to match any preamp with RCA jacks # Hibachi-II's have External Access Speaker Protection Fuses Supplied with 4-Amp speaker fuses for 200W rated speakers, Use 3-Amp speaker fuses for <200W speakers # 17 Pounds Each # 13-1/2" x 11" x 9" Tall to top of binding posts # Giant toroidial high current 8-pound power transformer with smart sensing vacuum tube filter and huge film bypassed filter cap array # Self test power up: Red light speaker disconnected for 2-seconds then relay clicks to Green light # Draws very light current idling silent (12-watts), <1mV ripple hum, for convenience can be left on - read next line # A Power Conditioner with relay disconnect surge protection is highly recommended to protect your valuable audio equipment # Large WBT Style gold 5-way speaker wire binding posts accept all wire gauges # Versatile high quality 4-Way Solid Nickel RCA's: Use one RCA for the normal mono block input. Combine L & R preamp signals on the amplifier using 2 RCA jacks to make mono for a center speaker. Has 2 more RCA jacks to easily daisy chain another amp for bi-amping. Can use the extra jacks for HT: Connect both your HT processor and your 2-chan pre-amp outputs to this amplifier at the same time - has a unique TAD designed isolation network on the RCA jacks.