PrimaLuna Dialogue Premiem HP Inegrated Amplifier -Silver **Clearance**

**EL34 tubes/ 70 watts per channel**

The HP: Now you can own an iconic product that is built to last a lifetime. Like all PrimaLuna products, it will be both relevant and desired decades later. Here are the features:

• 
  Point to point wired with Swiss made cable. It's obvious that point to point wiring sounds better and lasts longer than wave-soldered thin printed circuit boards. It's what sets PrimaLuna apart and is part of our credo. In the new DiaLogue Premium we went a step further by using Swiss-made, silver-plated, oxygen-free continuous crystal (OCC) copper with a Teflon dielectric in the critical signal path for superior signal speed and increased clarity.
  
  
  


• 
  TAKMAN Resistors. If you bought a lesser preamp, you would pay hudreds to make this upgrade. Easy to identify through there pink color, these premium resistors made in Japan are popular with those who rebuild and upgrade there gear. "Modders" love TAKMAN for their low noise, linearity, and musicality.
  
  
  


• 
  SCR Tinfoil Caps. Made in France, these capacitors are used in the critical signal paths and while they are expensive, the PrimaLuna team they could not be left out after careful listening comparisons with many different types.
  
  
  


• 
  AC Offset Killer. A PrimaLuna exclusive. This is another PrimaLuna "magic bullet" design to make our products so quiet, you will get goose-bumps. PrimaLuna's parent company Durob Audio B.V. sells this as a stand alone item under the Ah! brand name. The fabulous company P.S. Audio sold something similar as a "Humbuster". It's job is to keep the main AC power transformer as quiet as possible. PrimaLuna custom-winds superb AC toroidal transformers that are low in hum. This circuit takes it a to a place no other manufacturer dreams of going. Adding this to your stereo would cost hundreds. 
  
  
  


• 
  New front-end circuitry. The DiaLogue Premium uses three 12AU7 tubes per channel. The result is even lower distortion and increased bandwidth. The change in dynamic range is stunning! Distortion levels in the first stage have dropped by a factor of five at low levels, and at least 20 at higher levels, above one volt. The four 12AU7’s on the outside are driver tubes. By using four instead of two, we can swing more voltage. The two tubes in the center are the input tubes, and that’s where you want to have fun later if you wish by experimenting with different tube brands.
  
  We chose 12AU7 tubes because there are more factories around the world making great ones today than any other tube, so you can try them and see if you prefer their "color." By contrast, a tube like the 6H30 tube is well-known for thin mids, and they are only made in one factory in Russia. If your equipment uses that tube, there is no way to fine-tune the tonal balance of your system trying different brands; you'd better like it as-is. What if that 6H30 factory has a problem, closes, or just decides to stop making them? In addition, because 12AU7's have always been a popular tube, there are tens of thousands of vintage new-old-stock 12AU7's available everywhere from the greatest factories like Telefunken, Mullard, Amperex, Cifte, Siemens, and more. Tons of them. If you haven't "Tube Rolled," it's a gas, and how you get that last 10% of PERFECT tonal balance to YOUR tastes. 


• 
  Dedicated subwoofer output. If you're favorite sub only uses line-level inputs, such as the JL Audio subwoofers, the DiaLogue Premium Integrated makes it simple to use!