Dr. Feickert AnalogueCleanusedDr. Feickert Clean Turntable battery power supply unitUnit was in use several years. Has been sent for new battery pack ( new installed at Dr.Feickert factory ) technical check done. The unit has b...1300.00
Dr. Feickert Clean Turntable battery power supply unit
Unit was in use several years. Has been sent for new battery pack ( new installed at Dr.Feickert factory ) technical check done. The unit has been sealed and signed of at Feickert factory - not used since. So you basicly get the unit fully technicly checked with new batteries. As can be seen on photos attached.
The Clean Continuous Battery Power Supply (CBPS) is the new innovation in audio technology by Dr. Feickert Analogue. It is the first un-interruptable DC power supply capable of providing continuous clean power to your turntable, 24 hours a day, 365 days a year...
This Clean CPBS was built to fully isolate Dr. Feickert Analogue turntables, or any other appropriate device, from the distortion and noise coming from the AC power line. Additionally, it prevents noise that may be generated by your Feickert turntable’s switch mode power supply unit (PSU) from affecting the AC power going to any of your system’s associated equipment. The performance of each and every Feickert turntable is elevated when using this power supply. Installing and using it is effortless. Simply plug it in between the power supply and your Feickert turntable. Could it be any easier?
For this new piece, Dr. Feickert Analogue has emplimented an extremely innovative charging technology that avoids any detrimental memory effect on the NiMH batteries used in. This technology carefully considers the chemistry of the batteries and avoids any over-voltage when charging. Monitored by a micro-controller, the batteries cannot be overcharged (overcharging is the main reason for memory effect and the resulting battery degradation.). Dr. Feickert Analogue's technology preserves your investment, while helping to preserve the environment.
The Clean CPBS is able to run full time on battery power by using two independently working battery circuits. Each circuit consists of four blocks of 6-volt battery packages. The micro-controller measures the charge being taken from the batteries and monitors the voltage. At a defined minimum power level the micro-controller automatically switches the battery lines in less than one millisecond and starts recharging the circuit previously in use. The result is the purest and cleanest DC one can get... no ripple, no noise, no mains distortion – nothing but purity of sound beyond your expectation.