Scout jr Turntable - The Budget Reference

our demo unit about 30 hrs on it  --full warranty

with ortofon 2m red cartridge  

Everything the world loved about the Scout now is now in a simplified pre-mounted package! It is astounding how good this combination sounds on the VPI Reference systems:

• JBL Everest’s, DSA phono section, ARC REF 5SE preamp, VAS Citation 2 mono amps


• KEF Blades, VAS transformer, Mac 2500, Mac 452 power amp

The VPI Scout Jr. is a ready to use out of the box high-end entry level turntable, complete with a pre-mounted Ortofon 2M Red cartridge. The new tonearm is 9 inches long with a Yoke type vertical bearing and turntable like horizontal bearing, it is the perfect solution to enjoying your music!  The arm is damped in the horizontal plane and free in the vertical plane, this combination breaks up resonances and ads to the enjoyment of the sound. 
The Scout Jr. uses a 600 RPM (500 RPM overseas) AC synchronous motor to drive the turntable.  This is a precision device that is mounted in a separate box on rubber feet for the ultimate in motor noise isolation.

The Scout Jr. Turntable is a precision instrument thoroughly tested.  Besides being mechanically tested every Scout Jr. is also musically tested using a PS Audio Sprout and KEF Headphones.

The Table:

• 1.25”" thick black textured vinyl covered non-resonant MDF chassis.


• 16" x 11" footprint 


• 19” x 14” x6” overall size


• Machined 1” thick 6061 aluminum platter. Damped internally.


• Platter rotates on an oil bath bearing and fitted to shaft with a #2 Jacob’s Taper for a concentric rigidly mounted coupling. 


• The bearing has a PEEK thrust disc and machined graphite impregnated brass bushings using a Thompson Engineering 60 Rockwell case hardened shaft. 


• 600 RPM AC synchronous motor is contained in a separate steel housing and drives the platter with smooth, quiet operation. 


• Includes a record damping mat.  

The Arm:

• New 9” vertical Yoke type Scout Jr. Tonearm with lateral turntable type bearing.


• Pivot to spindle: 223mm


• Effective length: 240.7mm


• Overhang: 17.7mm


• Offset angle: 22.85 degrees


• Average RMS distortion: .36%


• VTA adjustable arm mount.


• Damped stainless steel armtube.


• Very pure copper wire, twisted with special insulating jacket.

The Cartridge:

• Comes supplied with an Ortofon 2M Red pre-mounted at the factory.  No need for any adjustments when you use the turntable.

• available from :


• Quest For Sound
  2307-R Bristol Pike
  Bensalem Pa
  19020
  215-953-9099
  www.questforsound.com
  [email protected]