VPI debutes its 30th Anniversary "CLASSIC TURNTABLE"
new in box ...full warranty -
please contact us direct with questions at --email@example.com
The VPI Classic Turntable comes standard with the unipivot JMW-10.5i tonearm Special Edition in rigid mount mode. The Classic Turntable uses new VPI pure copper wire, a solid plinth with black oak or walnut finish (at no additional cost), a solid mounted AC synchronous motor, new cast aluminum platter , silent inverted bearing, and new isolator feet derived from the HR-X. .
The sound of the Classic Turntable is fast, clean, wide open, with deep powerful bass, and unequalled in speed stability. The Classic Turntable gives any turntable made regardless of price a serious "run for the money."
This completely new design has produced the simplest and one of the best sounding VPI tables to date.
VPI "Classic Turntable" Features:
Special Edition JMW-10.5i SE tonearm - By giving up "vta on the fly" adjustments, you get most of the sound of the highly reviewed JMW-10.5i tonearm. A new less expensive base and mounting saves hundreds of dollars but gives up little in sound.
New investment cast aluminum high inertia platter with precision inverted bearing.
Speed stability on par with a master tape - Due to the rigid mounting of motor - platter - tonearm there isn't any random motion to cause speed instabilities.
Noise rejection allowing the "Classic Turntable" to sit on a wood shelf near four 15" subwoofers and having virtually no feedback.
Lack of random motion between the motor - platter - tonearm gives the ultimate in low level resolution. Not only does this rigidity improve speed stability, it also allows the retrievel of low level information with the world's great turntables and pushing against master tapes.
Absolutely solid, non-resonating laminated one-piece chassis holding all comonents. This is not a wooden frame; it is a solid laminated 2.5" thick MDF block with 11 gauge steel attached to the top with silicone and long bolts through all the layers. The chassis weighs 30 pounds and is totally non-resonant.
Real black oak or walnut wood veneer finish.
RCA jack termination so you can use the interconnect of your choice.
Tonearm anti-skate - For those that require the fine adjustment of anti-skate, it is standard on the JMW-10.5i SE.
Optional lift off full dustcover is available.
Optional periphery ring clamp.
Optional SDS power supply.
20.75" W x 15.75" D x 10" H (Including tonearm wire loop)
Weight: 45 pounds
MORE INFO -- CLICK HERE Quest For Sound
Avaliable from :-
QUEST FOR SOUND ** 2307-R BRISTOL PIKE *** BENSALEM PA 19020
215-953-9099 *** FAX- 215-953-9982*** QUESTFORSOUND@AOL.COM
WEB SITE --http://firstname.lastname@example.org