Outlaw Audio 7100 7-Channel Amplifier

Designed and built in the United States, the 7100 features high quality parts and
modular configuration. Each channel has four discrete output devices
and 20,000 microfarads of total filter capacitance. With all channels
driven, the 7100 is capable of 100 watts/channel into eight-ohm loads;
it can reach 165W x 7 with four-ohm loads. Total harmonic distortion is
vanishingly low at <0.05% at rated output, all frequencies,
and at <0.01% at 1 kHz. Other significant ratings include a power
bandwidth of 5Hz - >100 kHz +0/-3 dB; a damping factor >400 from
10Hz-400Hz; -90dB crosstalk from 20Hz-20kHz, and a slew rate of
50V/usec. One volt of input signal will drive the 7100 to full power.

At the heart of the amp's high current power supply is a 1.2kVA
toroidal transformer with two separate windings for each channel,
ensuring enough current for even the most demanding transients and
special effects. The need for cooling fans is eliminated by individual
heatsinks for each module. Protection circuits include heat sensors and
over-current detectors. A low-voltage trigger input allows timed
remote power-up and power-down with preamps and processors similarly
equipped.

There are 2 small blemishes on the top, which are highlighted in separate images. Additionally an overall image of the top is provided to show these blemishes are not very noticeable and could probably be buffed out.

Original Product Page: https://www.outlawaudio.com/products/7100.html
Additional Review Page:  https://hometheaterhifi.com/volume_10_2/outlaw-audio-7100-power-amplifier-6-2003.html

Power Output: 7 x 100 watts @ 8 ohms, 20 - 20kHz, 0.05% THD, All Channels Driven
7 x 165 watts @ 4 ohms, 20 - 20kHz, 0.05% THD, All Channels Driven

Signal to Noise: 119dB "A" weighted

Frequency Response: 20Hz. -20kHz. +/- 0.1 dB at rated output

Total Harmonic Distortion: < 0.05% at rated output, all frequencies, 0.01% at 1 kHz.

Intermodulation Distortion: < 0.05% at rated output.

Power Bandwidth: 5Hz - >100 kHz +0/-3 dB

Damping Factor: > 400 from 10 Hz to 400 Hz

Crosstalk: > -90 dB from 20 Hz to 20Khz

Gain: Voltage gain of 28

Slew Rate: 50v/Microsecond

Input Impedance: Nominal 50k ohms

Input Sensitivity: 1.00 Volts for Full Rated Output

Remote Trigger Voltage: 3 - 32 Volts DC at 5 milliamperes or greater

Dimensions: (HxWxD): 5" with feet x 17.2" x 16.2"

Weight: 51 lbs

Power Requirements: 115VAC, +/- 3%, 50Hz - 60 Hz. 1200 watts, maximum