Vandersteen 3a Sig

I am the second owner of this pair,  purchased used from original owner and fellow A'gon member in March of this year.  I drove 2 hours to fetch them and it was well worth the trip.

Consecutive serial # 11074A & 11075A.  According to Vandersteen these were manufactured around 2003/2004.

NOTE: included: Sound Anchor stands,  Owners manual & associated reviews etc. as well.   

 Vandersteen recommends bi-wire cables. The Anticables pictured are included as well.  These have the smaller spades that fit Vandersteen specifically. Bananas on the amp end. 

 
Some nicks and imperfections on the wood bases, and the cloth socks could use,  but don't immediately require replacement.  I called Vandersteen and the pair of socks would cost the new owner about $150 - there's even a Youtube video documenting how to do it if you're so inclined.  I wasn't,  and I didn't - they look fine from any listening distance. 
 
The specs from the site :

  

Tweeter

1” Exclusive Dual-Chamber, Transmission-Line Loaded, Ceramic-Coated Alloy Dome with Ferrofluid Voice-Coil Cooling

Midrange

4.5” Reflection-Free Tri-Woven Composite Cone with Die-Cast Aerodynamic Basket and Magnet System with Ferrofluid Voice-Coil Cooling

Woofer

Active Acoustic Coupler

10” Dual-Spider Aluminum Alloy Cone with Die-Cast Basket, Heavy-Duty 1.5” 4-Layer Voice Coil with Ventilated Aluminum Former, 60 oz. Magnet Structure with Focused-Field Pole Piece and Copper Rings

Phase

Recommended Amplification

Frequency Response

26Hz – 30kHz +/- 3dB

30Hz-22kHz +/- 1.5dB

Sensitivity

87 dB, 1 meter/2.83 volt input

Impedance

6 ohms nominal 4 ohms minimum

Crossovers

First order/6dB per octave, 80Hz, 600Hz, 5kHz

Input Terminals

Barrier strips, 7/16" max width

Dimensions (WHD)

16” x 48” x 10.25”

Weight

90 lbs. Ea. Net


Local pickup only.  THESE ARE HEAVY AND SO ARE THE SOUND ANCHOR STANDS!  VERY WORTH THE WHILE OF PICKING THEM UP - THESE ARE ONE OF THE BEST BUYS YOU CAN MAKE IN LOUDSPEAKERS.