AudioQuest Earth Balance Audio Interconnects - 2-Meter Pair: DEMO/WARRANTY

Audioquest EARTH Balance Interconnect with DBS System in two(2) meter pair.  The Earth balance interconnect is a demonstration pair of cables and used very lightly.  The cables are complete with the box, netting for ends and carrying case.  Cables will include full warranty with a provided bill of sale.  The cable rates a 10 out of a 10. 
Shipping – Included with purchase of the cable within Canada and most contiguous United States(lower 48 states) only. Shipping cost is added to buyers in Alaska, Puerto Rico, Hawaii,  Guam and Virgin Islands.

Audioquest Earth - Balance Interconnects

Solid
Perfect-Surface Copper+ (PSC+) Conductors

Solid conductors
prevent both electrical and magnetic interaction strand-to-strand interaction,
major sources of distortion. Surface quality is critical because a conductor
can be considered as a rail-guide for both the fields within a conductor, and
for the magnetic fields that extend outside the conductor. The astonishingly
smooth and pure surface of all AudioQuests’s Perfect-Surface metals nearly
eliminates harshness and greatly increases clarity compared to lesser
materials. Extremely high-purity Perfect-Surface Copper+ further minimizes
distortion caused by grain boundaries, which exist within any metal conductor,
nearly eliminating harshness and greatly increasing clarity compared to OFHC,
OCC, 8N and other coppers.

FEP Air-Tube
Insulation (FEP Is a Fluoro-Polymer)

Any solid material
adjacent to a conductor is actually part of an imperfect circuit. Wire
insulation and circuit board materials all absorb energy (loss). Some of this
energy is stored and then later released as distortion. Air, however, absorbs
next to no energy, and FEP is the best extrudable solid insulation, absorbing
less energy than other materials. The use of FEP Air-Tube insulation, with
almost nothing but air around the solid PSC+ conductors, improves the sound of
an audio system's focus and dynamics.

Triple-Balanced
Geometry (Separate Ground-Reference Conductor)

Our Triple-Balanced
Geometry uses a separate ground-reference conductor, so the cable's shield is
never used as an inferior conductor. Whether prepared with RCA or XLR plugs, the
cable's three conductors ensure that the positive and negative signals have
equally superior, low-distortion conducting paths.

Carbon-Based
6-Layer Noise-Dissipation System (NDS)

It's easy to
accomplish 100% shield coverage. Preventing captured Radio Frequency
Interference (RFI) from modulating the equipment's ground reference requires
AQ's Noise-Dissipation System (NDS). Traditional shield systems typically
absorb and then drain noise/RF energy to component ground, modulating and
distorting the critical "reference" ground plane, which in turn
causes a distortion of the signal. NDS's alternating layers of metal and
carbon-loaded synthetics "shield the shield," absorbing and
reflecting most of this noise/RF energy before it reaches the layer attached to
ground.

Dielectric-Bias
System with Radio Frequency Trap

All insulation
between two or more conductors is also a dielectric whose properties will
affect the integrity of the signal. When the dielectric is unbiased,
dielectric-involvement (absorption and non-linear release of energy) causes
different amounts of time delay (phase shift) for different frequencies and
energy levels, which is a real problem for very time-sensitive multi-octave
audio. The inclusion of an RF Trap (developed for AudioQuest’s Niagara Series
of power products), ensures that radio frequency noise will not be induced into
the signal conductors from the DBS field elements. (DBS, US Pat #s 7,126,055
& 7,872,195 B1)

Cold-Welded, Hanging-Silver Plating
Directly Over High-Purity Red Copper Plugs

https://www.audioquest.com/cables/analog-interconnects/elements-series/earth