Mark Levinson 20.6 Monaural power amplifiers
Listed · 431 Views
This listing has ended.
Listings Similar to Mark Levinson
Time Left: Listing Sold
This listing has ended.
Condition | |
Payment methods | |
Ships from | Kailua-Kona, HI, 96740 |
Ships to | United States |
Package dimensions | unspecified |
Shipping carrier | UPS |
Shipping cost | Free |
Average | Research Pricing |
These Mark Levinson mono blocks were purchased in 1995 from Wilson Audio to drive a Wilson Audio WAMM speaker system. We had ten years of delightful listening with this setup.
In 2011 both amps were sent to Pyramid Audio for a complete going over. Pyramid Audio is a Mark Levinson authorized service center. They replaced most capacitors and have assured me they are both operating at factory specs. They have been boxed and stored since being returned from Pyramid.
The amplifiers have some small scratches on the front handles and one amp has a small dent on the rear heat sink fin, not visible from the front.
The amplifiers will be shipped sturdy boxes provided by Pyramid Audio.
Specifications:
Output: 100W into 8 Ohm, 200W into 4 Ohm, 400W into 2 Ohm.
Amp dimensions: 17.5"W x 8.4"H x 22.1" D
Weight: 65 lbs. each, shipping weight 90 lbs. each.
Included are two Tsunami Plus 6ft Power Cables, three Fisher RCA/Camac input adapters, 4 Speakon to Large Binding Post adapters; and 2 Neutrik Speakon cable end connectors. (see photos)
You may to refer to Stereophile website www.stereophile.com for a review of these great amps.
The unit will be sold as-is. No returns will be allowed.
No questions have been asked about this item.
Ask the seller a public question
You must log in to ask a question.
Return Policy
Return Window
Returns are not accepted on this item.