Berning P-1 Preamplifier
Listed · 1953 Views
This listing has ended.
Listings Similar to Berning
Time Left: Listing Sold
This listing has ended.
| Condition | |
| Payment methods |  |
| Ships from | Oakland, CA, 94611 |
| Ships to | Worldwide |
| Package dimensions | ?" × ?" × ?" (6.0 lbs.) |
| Shipping carrier | unspecified |
| Shipping cost | Specified after purchase |
 Average | Research Pricing |
Amended on
$1 NO RESERVE - the installed Mullard tubes alone are worth over $600! -
Rare Berning Tube Preamplifier with phono pre and mono switch --
Hand Built by David Berning with point-to-point wiring - no circuit boards --
Serial Number 18 (only ~ 25 ever made) --
Uses four 12AX7 tubes - I recently installed 4 brand new NOS Mullard 4004 tubes with a total of under 50 hours usage - $169 each on Tubedepot --
Unusual power input via male prongs on back of chassis (see pics)- I will include a Shunyata adapter that will allow the use of any 15amp IEC powercord. --
Superficial scratches on brushed aluminum face and back (see pics) --
PAYPAL PREFERRED - no fees
Amended on
$1 NO RESERVE - the installed Mullard tubes alone are worth over $600! ----
Rare Berning Tube Preamplifier with phono pre and mono switch -----
5/10 rating only because of superficial swirls and mild scratches on faceplate and back panels. Looks fine from a few feet away. --
Amended on
CLARIFICATION - apologies for this late edit - the knob on the right marked " volume" is for volume control ---- the one on the top to the left of the volume control is a balance control: left to right --- easier than separate volume controls for each channel
Amended on
THIS ONE HAS A SINGLE VOLUME CONTROL - AND A BALANCE CONTROL
$1 NO RESERVE -
Rare Berning Tube Preamplifier with phono pre and mono switch --
Hand Built by David Berning with point-to-point wiring - no circuit boards --
Serial Number 18 (only ~ 25 ever made) --
Uses four 12AX7 tubes - I recently installed 4 NOS Mullard 4004 tubes with a total of under 50 hours since installation --
Unusual power input via male prongs on back of chassis (see pics)- I will include a Shunyata adapter that will allow the use of any 15amp IEC powercord. --
Superficial scratches on brushed aluminum face and back (see pics) --
PAYPAL PREFERRED - no fees
Questions for the seller |
|---|
| do these have covers or are they open as photographed? if you look very closely at the last pic, you can see just a bit of the side of the cover |
Ask the seller a public question
You must log in to ask a question.
No policies have been specified.
