One owner trade-in. Includes original factory packaging.
Amps must ship freight due to weight. Insured. and strapped to a pallet for safe arrival. Shipping cost to be determined by buyers address. Estimated weight, 350-450 lbs.
Philosophy is the most important aspect of any design, CAT's philosophy is to design their products to neither add to, nor detract from the music. They never attempt to cover up a design problem with another problem, nor do they try to introduce a supposedly complementary problem to "Synergise" with it. Two wrongs do not make a right. Only the eradication of the problem is correct..
The JL3 is CAT's statement amplifier. The culmination of sixteen years of amplifier research. Following their philosophy of design, the JL3 is not designed to sound like a tube amplifier or a solid state amplifier or any sort of cross between them..
This amplifier has been designed to allow the sound of the music to flow through, uncoloured and unencumbered by the sound of any electronic technology. The success of this design establishes a new paradigm for amplifier design amongst true music lovers everywhere.
Power Supply The power transformers are enclosed in separate nickel plated steel housings to contain the magnetic field. The isolation transformer eliminates entry of AC power line noise into the amp, yielding greater benefits than add-on conditioners without any of their sonic drawbacks or expense. Slow filament Power-Up extends tube life greatly. The quadruple Cascade Audio Power Supply uses time compensated zero feedback mosfets and vacuum tubes to deliver unequalled dynamic contrasts, transparency and sound stage realism.
Circuitry Power Triode audio circuitry produces tonal natural music by eliminating partition noise inherent in pentode designs and the resulting noise intermodulation ("grain") Low feedback (about 5dB) properly compensated design eliminates the tonal hardness of high feedback and/or improperly compensated designs whilst yielding more consistent sound quality..
Ultra-wide open loop in-circuit bandwidth of the output transformers enables operation of the amps closed loop response entirely within the open loop response, eliminating any requirement for the output stage to perform beyond its natural capability. Unprecedented stability into complex speaker loads.
Chassis The heavy steel chassis is reinforced with several welded beams for tremendous strength and elimination of low frequency vibration, yielding incredible bass solidarity. Constrained damping layer on top plate silences vibration before it can be converted into electro-mechanical noise. The output transformers are enclosed within their own magnetically solated housings which is lined with Birch plywood, one of the most musical woods, and potted in place with a combination of epoxy and elastomers for mechanical stability and control. Mechanical isolation from floor vibrations provided by high loss viscoelastic feet.
Convenience Mirror polished stainless steel maintains lustre and brilliance with minimal care. Single 10 turn master bias control per channel assures utmost sonic capability with minimum effort. Built in LCD meter. Quality Exotic low loss aerospace circuit board material. CAT wire uses ultra pure dead soft annealed copper and super low loss insulation - 7 times lower than TFE Teflon!
CAT coupled capacitors reduce electromechanical noise to incredible levels. Low loss core material has 92% less hysteresis loss than grain orientated silicon steel used in all other transformer coupled amplifiers, and almost 100 times greater linearity..
Specifications: Power 150 watts nto 8 ohms - class A 200 Watts into 4 ohms - class A Frequency Response 1 Hz to 75 KHz (+0, -3dB) Gain 30.6 dB (8ohms) Sensitivity 835mV AC for full power (8 ohms) Noise 110 dB below full power Power Bandwidth 10 Hz to 30 kHz Damping factor 108 Dimensions 27" x 18.5" x 10.5" (L:W:H) 68.6 x 47 x 26.7 cm Weight 180 lbs. (82kg) each