Schiit Audio Aegir Amplifier for speakers

Schiit Audio Aegir Stereo Continuity Power Amplifier in silver. Comes in original box with owner's manual and AC Power Cord. The amp is 4 months old. I purchased 2 Aegir amps and I decided that one has all the power that I need.

Stereophile Recommended Component: A (Solid State) Schiit Aegir

The solid-state Aegir amplifier uses a proprietary class of operation called Continuity, which gets around certain limitations of class-AB operation—particularly transconductance droop beyond the class-A power envelope—by means of a current-feedback topology. It's specified at 20Wpc into 8 ohms and 40Wpc into 4 ohms and runs a bit hot—but not as hot as one might expect from a pure class-A amp of the same output. HR described the "titillating physical pleasures" of the made-in-California Aegir driving Wharfedale Linton loudspeakers as something he could "live [with], satisfied, forever," and praised the pairing of Schiit Aegir and Harbeth P3ESRs as offering "80% of the . . . detail-rich humanity" he hears from his $4000 reference amplifier. In measuring the Aegir, JA found higher than specified output power—28Wpc into 8 ohms, 43Wpc into 4 ohms—and described the Schiit as "a well-engineered amplifier at an affordable price." Herb's conclusion: "a design that will withstand and even rejoice in the scrutiny of time." (Vol.42 No.10 WWW)

https://www.stereophile.com/content/recommended-components-fall-2020-edition-power-amps

Power Output:

Stereo, 8 Ohms: 20W RMS per channel
Stereo, 4 Ohms: 40W RMS per channel
Mono, 8 ohms: 80W RMS

Frequency Response: 20Hz-20Khz, -0.1db, 3Hz-500KHz, -3dB

THD: <0.01%, 20Hz-20KHz, at 20W RMS into 8 ohms
IMD: <0.01%, CCIR, at 20W RMS into 8 ohms

SNR: >112db, A-weighted, referenced to full output

Damping Factor: >100 into 8 ohms, 20-20kHz

Gain: 12 (22dB)

Input Sensitivity: AKA Rated Output (Vrms)/Rated Gain. Or, 14.3/12. You do the math.

Input Impedance: 22k ohms SE, 44k ohms balanced

Crosstalk: >95dB, 20-20kHz

Inputs: L/R RCA jacks for stereo input, single XLR for mono input

Topology: Fully complementary, all-BJT, current feedback, no coupling capacitors or DC servos with Continuity™ constant transconductance output stage

Oversight: microprocessor-controlled monitoring and management of critical operational points, including DC offset, with standby mode and relay shut-down for overcurrent, thermal, and other faults

Power Supply: 600VA transformer with dual mono main rails, plus boosted, regulated supply to input, voltage gain and driver stages, plus separate, isolated and regulated rails for microprocessor management.

Power Consumption: 450W maximum

Size: 9” x 13” x 3.875”