Bryston 14B SST Pro 2 Channel 600 Watt Amp - Pro Model ~ Built Like a Tank!

This is a beautiful two channel solid state POWER amplifier rate at 600 Watts per channel into 8 ohm and 900 watts into 4 ohm.  Actually tested output by Bryston is at 642 watts RMS on the spec per channel into 8 ohm.  This amp powered my 6 ohm LSA statements with deep mid bass punch and solidity with great midrange and highs.  Also worked well with my Sonus Faber Guarneri with utmost transparency and wide open soundstage.    

This beefy, rugged and reliable amplifier is fully covered by Bryston's very complete transferable warranty until 2025, but is built like a tank and according to Chris Russel, "built to last 50 years...".      

Overall the condition is great for age with little to mention.  Please look at pictures to show any minor wear.  Front is clean and without defects.  Lights operate normally and this has never been serviced.  Given an 8/10 rating, because of age and some buyers maybe very picky, but I would personally rate this higher.    
Many audiophiles prefer this model over the 7B SST for sonic qualities, Bryston got it right with this one!  Also, you will spend less on only one good cord for this bad boy.
 
This is the PRO model with balanced and single ended inputs (for short or longer runs from your source), input select, sensitivity (1v for 23dB or 2v for 29dB of gain ~ 2v is ideal for systems where the volume control rotation is limited to the bottom half of the control or less) and level control to fine tune your sound (this will attenuate the input signal level from 1 dB through -14 dB).  Also comes with a 12v remote trigger to control another device or have another device power this bad boy on as well.  19" faceplate which will support rack mounting (has handles currently).  Accepts spaded (up to 5/16 in. or banana plugs. The master circuit fuse (or any) has never been replaced because this has be used generate normal volume levels and has never clipped.     
 
Please goto bryston.com/PDF/Manuals/14BSST_MANUAL.pdf for more specific information from the manual.      
 
If you desire the raw power to drive two channel amplification then this amp is for you. This amp will require a 15 amp power cord that is not included.    
  
Packed in the original box and packing and will be insured to your destination in the contiguous USA.  This amp is heavy at 86 lbs. and will require insurance so there are no issues.  Shipping will be the responsibility of the buyer.  Offer for will call in the SF bay south bay area.     
 
Insured shipping will be charged $150 and I will refund the difference from actual shipping if it is less. I am not looking to profit from shipping and look to provide a fair transaction.    
 
Paypal, please add 3.0%    
Credit, please add 2.8%   
 
Please see my feedback and also check out Pure_Life_Audio on eBay for 17 years and a perfect score.     

Enjoy the sound!     
 
Please call or message me anytime before the transaction to answer any questions, but I do have a day job and may need a few hours to reply.     
 
MZ (408) 410-5909  
 
Other stats:
Description: Solid-state, dual-mono power amplifier with balanced and unbalanced inputs. Specified output power (at 2kHz): 600Wpc into 8 ohms (27.8dBW), 900W into 4 ohms (26.5dBW). Distortion: 0.007%, 20Hz-20kHz. Intermodulation distortion: 0.002%, 60Hz+7kHz, mixed 4:1. S/N Ratio: 112dB ref. full output, input shorted, 20Hz-20kHz bandpass. Power bandwidth: 1Hz-100kHz -3dB. Damping factor: >300 at 20Hz, ref. 8 ohms. Input sensitivity: 2.2V unbalanced, 4.5V balanced, both for full output. Input impedance: 50k ohms unbalanced, 20k ohms balanced. Polarity: noninverting.
Dimensions: 19" (490mm) W by 7" (180mm) H by 19" (490mm) D. Weight: 85 lbs (38.5kg) net.
Price: $5995.  
 
Read more at http://www.stereophile.com/content/bryston-14b-sst-power-amplifier-specifications#wSTfrxPou7Kf8UJP.99


Reviews:
http://www.audioreview.com/cat/amplification/amplifiers/bryston/14b-st/prd_124701_1583crx.aspx