Emotiva XPA-200 Stereo Amplifier

XPA-200 Stereo Amplifier

Includes: Power Cord and Original Double Boxes. The front panel display still has the protective film (applied at the factory).

Specifications Topology: 

Fully discrete, dual differential, high current, short signal path Class A/B. 

Number of Channels: 2 

Power Output (rated power; THD < 1%): 

150 watts / channel; into 8 Ohms; both channels driven. 240 watts / channel; into 4 Ohms; both channels driven. 

Rated Power Bandwidth (at rated power; 8 Ohm load): 

20 Hz to 20 kHz + / - 0.045 dB. 

Minimum Recommended Load Impedance: 

4 Ohms (which equals one 4 Ohm load or two paralleled 8 Ohm loads). 

Frequency Response: 10 Hz to 80 kHz (+ 0 / - 1 dB). 

THD + noise: < 0.02% 

Signal to Noise Ratio (8 Ohm load): > 89 dB at 1 watt (A-weighted). > 110 dB at rated power (A-weighted). 

Damping Factor (8 Ohm load): > 500 

Speaker Output Connections: 

Full-sized, 5-way binding posts; one pair per channel (two channels). 

Power Supply: 90,000 uF of storage capacitance. 360 VA heavy duty toroidal transformer 

Input Sensitivity (for rated power; 8 Ohm load): 1100 mV. 

Gain: 29 dB. 

Input Connections: Unbalanced (RCA); balanced (XLR); one each per channel. Input Impedance: 47 kOhms. 

Trigger: Trigger Input: 5 - 20 V (AC or DC); <10 mA input current required. Trigger Output: 12 VDC; can drive any load up to 50 mA. 

Power Requirements: 115 VAC or 230 VAC +/- 10% @ 50 / 60 Hz (automatically detected and switched). 

Front Panel Controls and Indicators: Standby; push button (halo ring changes color to indicate Standby or On).

Status LEDs (four); blue LEDs illuminate for normal operation, red LEDs ashes during power-on or when a fault occurs; (may be disabled by rear panel Status LED switch). 

Rear Panel Controls: AC Power switch; rocker switch (switches AC mains power).

Status LEDs switch; small slide switch on left (disables front panel Status LEDs and dims. Standby button halo lighting).

Input selector; toggle switch (selects between balanced and unbalanced inputs). 

Protection: The XPA-200 is protected against excessive operating temperature, shorted speaker connections, ground faults, and other common fault conditions. 

Dimensions: 17" wide x 3.875" high x 19" deep (includes feet and binding posts). 

Weight: 31 pounds unboxed (37 pounds boxed).