Plinius Hautonga Integrated Amp

!!!!!!! PRICE REDUCED !!!!!!!!!

Up for sale is my Plinius Hautonga Integrated Amp. I have rated this amp a 9 only because I am the second owner. Otherwise, this amp is in perfect condition.

Reduced price is firm.

 Features of the Hautonga

Phono Stage
 A high quality phono stage comes fitted as standard. With two gain settings and fixed loading it allows for trouble free playback with a number of MM or MC cartridges.
 
Line Out
 The Line out provides a line level output, carrying the selected source signal. The Line Out allows for the signal to go on to recording equipment, headphone amplifiers or sub-woofer speakers.
 
Remote Trigger Input and Output
 Terminals for remote trigger connection allow a processor signal to bypass the preamplifier stage or instigate the power amp to come out of standby.
 
Ground Lift Switch
 This allows for the signal ground to be isolated from the main chassis earth. This can assist in resolving unwanted ground loops or hum due to duplicate ground paths in some systems.
 
WBT and Neutrik Connectors
 High quality WBT RCA and Neutrik XLR input connectors are fitted along with WBT output speaker terminals to ensure low distortion interface between your cables and the amplifier.
 
Auric Wiring
 Audience AV supply the Auric OFC wire used in the input stage of the amplifier. The Auric was chosen for its high workability and natural sound.
 
AudioQuest Wiring
 AudioQuest X2 is used in the output stage of the amplifier as a high quality link to the speaker connectors.

Specifications 

POWER
200 watts RMS per channel into 8 ohms.
280 watts RMS per channel into 4 ohms.
Both channels driven from 20Hz to 20kHz at less than 0.2% total harmonic distortion

FREQUENCY RESPONSE
20Hz to 20kHz ±0.2dB
-3dB at 5Hz and -3dB at 70kHz

DISTORTION
Typically 0.2% THD and IM worst case prior to clipping

CURRENT OUTPUT
40A short duration peak per channel
Fuse protected

SLEW RATE
50V/µs

HUM & NOISE
90dB below rated output 20Hz to 20kHz unweighted

INPUT IMPEDENCE
47k ohms all inputs

RATED PRE OUT LEVEL
1.5V RMS into 47k ohms or higher

PRE OUT SOURCE IMPEDENCE
Typically 1.5k ohms

PRE OUT MINIMUM RECOMMENDED LOAD
47k ohms

LINE OUT LEVEL
190mV at 200 ohms

GAIN
Line inputs to speaker out: 40dB
Phono Input To Pre-Out: 66dB on high gain, 60dB on low gain

POWER/CURRENT CONSUMPTION
600W
0.4A (92W)
Class AB Idle 0.14A (32W) Standby

Dimensions
17.75" x 4.75" x 15.75"

Weight
30 lbs